Specifications; Minimum And Maximum Permissible Inlet Water Pressure - Kenwood KDW243A Instruction Manual

'

Specifications:

RATED VOLTAGE: 230V / 50Hz
RATED POWER: 1930W
A RATED ENERGY EFFICIENCY
A RATED WASH PERFORMANCE
A RATED DRYING PERFORMANCE
12 PLACE SETTINGS
7 PROGRAMMES
ELECTRONIC CONTROL
4 WASHING TEMPERATURES
24 HR DELAY TIMER
TOP SPRAY ARM
AUTOMATIC RINSE AGENT AND
DETERGENT DISPENSER
HALF LOAD
STAINLESS STEEL INTERIOR
GREY BASKETS
Minimum and maximum permissible inlet water pressure : 0.04-1.00 MPa.
This symbol on the product or in the instructions means that your electrical and electronic
equipment should be disposed at the end of its life separately from your household waste.There
are separate collection systems for recycling in the EU.For more information, please contact the
local authority or your retailer where you purchased the product.
Combination of soft
water and too much
detergent
Tea or coffee stains
Iron deposits in water
can cause an overall film
Hard water minerals
Dial is not in the OFF
position
Dishes block detergent
cups
Normal phenomenon
Aluminum utensils have
rubbed against dishes
This is normal
Overfill dispenser or rinse
aid spills
'
Dishwasher isn t level
12
Use less detergent if you have soft water and select a
shortest cycle to wash the glassware and to get them clean.
using a solution of 1/2 cup of bleach and 3 cups warm water
to remove the stains by hand.
You have to wait for 20 minutes after a cycle to let the heating
elements cool down before cleaning interior, to reduce the risk
of burns.
You have to call a water softener company for a special filter.
To clean the interior, use a damp sponge with dishwasher
detergent and wear rubber gloves. Never use any other cleaner
than dishwasher detergent for the risk of foaming or suds.
Turn the Dial to OFF position and slide the door latch to the
left.
Re-loading the dishes properly.
There is some steam coming through the vent by the door
latch during drying and water draining.
Use a mild abrasive cleaner to eliminate those marks.
A small amount of clean water around the outlet on
the tub bottom at the back of the tub keeps the water
seal lubricated.
Be careful not to overfill the rinse aid dispenser.
Spilled rinse aid could cause oversudsing and lead
to overflowing. Wipe away any spills with a damp cloth.
Make sure the dishwasher is level using the feet adjustment.