Advertisement
Getting Started: Installation and Adjustment Procedure (continued)
CHECK:
Touch the image:
Touch the image and check if the Initial-tool-bar
appears. Push the Internal Painter mode button,
and check if annotation can be done on the whole
image.
If the annotation is not accurate, please go back to
the CAMERA VIEW.
Check if the two dots are lit.
Also touch the image with fingertip and check that
the fingertip lit up in the CAMERA VIEW.
Check if the distance between your fingertip and the
image surface is within ¼" or less when the fintertip
starts to light.
If it's more than ¼" distance between, then go
through the ADJUST FT-01B process again.
Attach the cover:
Gently attach the cover so that it does not touch the
adjusting knobs.
Remove the adjusting bars from the whiteboard.
Trouble Shooting
Q. Can I mount the finger touch unit above my white
board?
A. No. The finger touch unit MUST be mounted on the same
surface as the display.
Q. How do I get a full image and full screen interaction
on my white board when using the finger touch unit?
A. You cannot. The finger touch unit MUST be mounted 2-4
inches above the image, and it also requires 2 inches between
the frame, if there is a frame. This means you have to shrink
the image to provide this requirement.
Q. Can I use the finger touch unit on an uneven surface?
A. No. The surface must be flat. An uneven surface, or a
surface with curve will cause inaccuracy.
Q. There is unintentional annotation or mouse cursor is
moving to the specific position.
A. Strong ambient light might, such as sunlight from the
window or incandescent light, can cause interference with
finger touch function. Please close the curtain or blind of the
window, turn-off the stand light close to the projector's image
and apply the AUTO or MANUAL CALIBRATION again.
All specifications are subject to change without notice. Hitachi will not be liable for any accidents or injuries that occur due to improper installation or improper usage of this device.
©2016 Hitachi America, Ltd. All Rights Reserved.
Touch the image with fingertip
Q. Will the chalk shelf on my whiteboard interfere with
my finger touch interaction?
A. Sometimes, yes. The reflection from the chalk shelf
sometimes interferes. There are "anti-reflection bars" included
with the finger touch unit for this reason.
Q. The position of mouse cursor is not matching with
the I-PEN tip / Fingertip. (i.e. The line I am drawing is 2
inches away from tip of the interactive pen.)
A. Push the CALIBRATION button on the remote and apply
AUTO or MANUAL CALIBRATION. If the gap still remains,
please go to the ADVANCED MENU -> IWB ->CALIBRATE
SETUP -> IWB AREA SETUP and set it to [MANUAL] and do
the calibration. Click the position of mouse cursor by iPEN at
the upper left and then click at the lower right.
Cursor
* Please apply this IWB AREA SETUP –[MANUAL] with PC
or MAC image on the screen.
Call: 800-HITACHI (800-448-2244)
Email: lcdprojector@hal.hitachi.com
Hours of operation:
Monday through Friday, 9:00 AM—6:00 PM EST
For complete information and installation instructions refer to
the FT-01B User's Manual or go to www.hitachiserviceusa.com
Initial tool bar
Cursor
HI0479-03/16
Advertisement
