Sony EVI-D70 Technical Manual page 11

Auto ICR Mode
Auto ICR Mode automatically switches the settings
needed for attaching or removing the IR Cut Filter.
With a set level of darkness, the IR Cut Filter is
automatically disabled (ICR ON), and the infrared
sensitivity is increased. With a set level of brightness,
the IR Cut Filter is automatically enabled (ICR OFF).
Also on systems equipped with an IR light, the internal
data of the camera is used to make the proper decisions
to avoid malfunctions.
When Auto Slow Shutter is OFF (PRESLOW mode
ON (default) or OFF)
ICR
IRIS
ON
OPEN
AGC
MAX
(Iris Open)
(Gain Max)
ICR ON
GAIN
Adjustable
Dark
ICR ON t OFF Adjustable
When Auto Slow Shutter is ON (PRESLOW mode
OFF)
IRIS
ICR
OPEN
AGC
ON
MAX
(Iris Open)
(Gain Max)
ICR ON
GAIN
(Slow Shutter Max)
Adjustable
Dark
ICR ON t OFF Adjustable
When Auto Slow Shutter is ON
(PRESLOW mode ON (default))
ICR
IRIS
ON
OPEN
AGC
MAX
(Iris Open)
(Gain Max)
ICR ON
GAIN
(Slow Shutter Max)
Adjustable
Dark
ICR ON t OFF Adjustable
IRIS
(Iris Min)
(0dB)
(1/60 sec)
SHUTTER
Bright
IRIS
(Iris Min)
(0dB)
(1/60 sec)
SHUTTER
Bright
IRIS
(Iris Min)
(0dB)
(1/60 sec)
SHUTTER
Bright
Note
When in Auto_ICR_OFF state and WB data is added (default), a
malfunction may occur when the subjects largely consisting of blue
and red colors are taken. Auto ICR is available in AE-full-auto
state only.
Camera ID
The ID can be set up to 65,536 (0000 to FFFF). As this
will be memorized in the nonvolatile memory inside
the camera, data will be saved regardless of whether it
has been backed up.
Effect
It consists of the following functions.
• Neg. Art: Negative/Positive Reversal
• Black White: Monochrome Image
Others
E-FLIP
This function turns the video output from the camera
upside down.
Mirror Image
This function reverses the video output from the
camera horizontally.
Freeze
This function captures an image in the field memory of
the camera so that this image can be output
continuously.
Because communication inside the camera is based on V
cycle, the captured image is always the one 3V to 4Vs after
the sending of a Command. Thus, you can not specify a time
period after sending EVEN, ODD or a Command.
Commands
• Power On/Off
Powers the camera on and off. When the power is off,
the camera is able to accept only the lowest level of
VISCA Commands; the display and other features are
turned off.
• I/F clear
Clears the Command buffer of the FCB camera.
Clearing the buffer can also be carried out from the
control application software when the power is on.
• Address set
VISCA is a protocol, which normally can support a
daisy chain of up to seven attached devices.
Therefore, whenever a camera is connected for the
first time, be sure to use the address set to confirm the
address.
Basic Functions
11