Electrolux ICON Use & Care Manual page 15

Door alignment:
The door should be parallel to the sides
and top of the appliance. If alignment is
necessary the door may be adjusted by
removing the grille, then loosening the two
screws which secure the door adjustment
bracket on the bottom of the door and
adjusting the door side to side. Use a
5⁄32" Allen wrench for this procedure.
When finished aligning the door, tighten
the screws securely and install the grille.
NOTE
Although not necessary, as the screws
in the door adjustment bracket can be
accessed with the door open, the grille
can be removed in the following manner.
• Loosen the two Phillips head
screws, one at each end of the
grill. It is not necessary to remove
them.
• With the door open raise up on
the end of the grille opposite the
hinges and pull toward you to
remove the screw from the keyhole
slot in the grille.
• Then pull the grille to the side to
remove the grille.
Installation is the opposite of removal.
Be sure to tighten the two Phillips head
screws.
Grille
Access to the phillips head
screws is through the top
end slots in the front of
the grille
Door should be
parallel to top
and sides of
the appliance.
Loosen (don't remove)
these two screws.
Maintenance
Keyhole slot
Rear of grille
Screw slot in grille
Door
adjustment
bracket
15
in grille