Installation method
Warning
This hand dryer must have its own independent
branch circuit using AWG #12 or #14 copper wire.
Use 120 Vac power.
Using the incorrect power supply may cause fi res,
fumes, electric shocks or malfunctions.
Check
□ 120 Vac power is being used.
□ Make sure that a ground-fault circuit interrupter is installed in the fixed wiring.
□ AWG #12 or #14 solid or stranded copper wire is being used for the power cable.
Make sure that a means for
disconnection is incorporated in the fixed
1
wiring in accordance with the wiring rules.
1.Remove the drain tank and air fi lter.
2
2.Remove the front panel mounting screws (2),
and remove the front panel.
Caution
Do not install when the product (power cable) is
electrifi ed.
Doing so may result in electric shocks.
Air fi lter
Front panel mounting screws
Front panel
− 6 −
Drain tank
Groove