Additional Safety Rules; Assembly And Operation; Clutch Handle; Clutch Torque Setting - Panasonic EY7410 Operating Instructions Manual

Read the Safety Instructions booklet and
the following before using.
I
. ADDITIONAL
SAFETY RULES
1) Wear ear protectors when using
the tool for extended periods.
Prolonged exposure to high inten-
sity noise can cause hearing loss.
) Be aware that this tool is always in
an operating condition, since it does
not have to be plugged into an elec-
trical outlet.
) When drilling into walls, floors, etc.,
"live" electrical wires may be encoun-
tered. DO NOT TOUCH THE CHUCK
OR ANY FRONT METAL PARTS OF
THE TOOL! Hold the tool only by the
plastic handle to prevent electric shock
in case you drill into a "live" wire.
) If the bit becomes jammed, immedi-
ately turn the main switch off to pre-
vent an overload which can damage
the battery pack or motor.
Use reverse motion to loosen jammed
bits.
5) During charging, the charger may
become slightly warm. This is nor-
mal. Do not leave the battery in
the charger for more than  hours
after charging is completed.
[Tool and battery charger]
Symbol
V
n
0
Revolutions or reciprocations per
.../min
Ah
Electrical capacity of battery pack
EY7410(EU).indb 5
Meaning
Volts
Direct current
No load speed
minutes
- 5 -
[Battery charger]
Read the operating instructions
before use.
For outdoor use only.
II
. ASSEMBLY &
OPERATION
 Hexagonal Bit Chuck
1. Attaching the bits
NOTE:
When attaching or removing drill
bits, disconnect the battery pack
from the tool and switch the lock
button into the lock position.
1. Hold the collar of the chuck and pull it.
. Insert the bit into the chuck.
. The collar will return to its original
position when it is released.
. Pull the bit to make sure it does not
come out.
5. To remove the bit, pull back on the
collar in the same way.
Bit
Hexagonal bit chuck
9.5 mm (/8") - 1 mm (00")
 Clutch Handle

(Clutch Torque Setting)

Adjust the torque to one of the 1 pos-
sible settings to the job. There is an
interval of about 0.1 N·m (1. k f-cm
or 1.1 in-lbs) between steps.
CAUTION:
Test the setting before actual opera-
tion.
Set the scale at this line.
6.5 mm (1/")
2006/07/19 17:27:42