Installation Tab - Sony SNC-CH110 User Manual

Date/time
Set the format of date/time and the separator. These
settings are applied to both Image 1 and Image 2.
Camera ID
Select the type of information displayed as Camera ID.
Set the Text string to be displayed.
Logo: Select an image file you want to use for Logo by
using the Browse... button, and click Upload to upload
the file.
Supported image file format: gif89a format (GIF
animation and transparent GIF format are not
supported.)
Maximun image size: 640 × 120
Number of horizontal pixels: An even number
Maximum file size: Approximately 50 KB
Notes
• Both Text and Logo cannot be used at the same time.
• Camera ID is applied to both Image 1 and Image 2.
• If the image size of the logo is larger than the image,
it cannot be displayed.
Image
Select whether to superimpose on Image 1 and Image 2
or not, set the font size and configure each item that
display position is assigned.
Superimpose
On/Off: When using the Superimpose function, select
On.
Font size: Set the font size.
Superimpose format
Set the items to superimpose according to the displayed
position. English one byte characters and symbols are
displayed. Available items are as follows:
• Off: Set not to superimpose.
• Text: Set to display a string that you want. You can
enter characters in the right free space.
• Date & time: Set to display date and time.
• Camera ID: Set to display Camera ID.
• Codec: Set to display the bit rate and frame rate.
• Zoom ratio: Set to display the zoom ratio.
• Camera direction: Set to display the name of a preset
position.
• Event: Set to display an event record.
Notes
• The items except for Off and Text cannot be set at the
same time.
• Depending on the length of the string you enter in
Text, the string display may crossover the other item.
In this case, change the display position or modify the
string.
OK/Cancel
See "Buttons common to every menu" on page 23.

Installation Tab

You can perform settings related to installation.
Aspect ratio
Select an aspect ratio for the image from either 4:3 or
16:9 for Image 1.
When you change this setting, the selectable value of the
image size of Image 1 in Video codec tab (page 32) is
changed.
Notes
• When Aspect ratio is changed, this unit restarts. It
takes about 2 minutes to restart.
• When Aspect ratio is set to 16:9, SolidPTZ cannot be
set to On.
• The settings below return to their defaults when the
aspect ratio is changed.
– Camera Menu the following settings of Video codec
tab are exceptions:
– Image size of Image 1: 1280 × 720 when set to
16:9, or 1280 × 1024 (CH210), 1280 × 960
(CH110) when set to 4:3.
– Frame rate of Image 1 (CH210 only): 30fps when
set to 16:9, or 20fps when set to 4:3.
– Position (all preset position will be cleared).
– Maximum detection size of motion detection:
1280 × 720 (CH110), 1920 × 1080 (CH210) when
set to 16:9, or 1280 × 960 (CH110), 2048 × 1536
(CH210) when set to 4:3.
Configuring the System — System Menu
27