Sharp UP-600 Service Manual page 27

6)-2. LOOPBACK Check
Checking
Install a straight cable between the RJ45 connector and the HUB
and execute the loop back test command to send and receive 1
packet of data.
Display
LOOPBACK Check
LOOPBACK : PASS (or ERROR)
LOOPBACK ERROR
LANC ERROR
How to exit the program
Press the CANCEL key to exit the program.
6)-3. MAC ADDRESS&FIRM Ver. read Check
Checking
The program reads the version of the MAC address and firmware
and displays the result.
Display
MAC ADDR&FIRM Ver. Read
MAC ADDRESS :
XX XX XX XX XX XX
FIRMWARE VERSION :
XXXXXXXXXX
How to exit the program
Press the CANCEL key to exit the program.
6)-4. MAC ADDRESS&FIRM write UTILITY
Operation
This utility writes MAC address and firmware.
(Procedure)
Install EPROM on the TCP/IP board and turn the IPL switch on
the board to the "program write mode."
Connect the board to the ECR and turn on the ECR.
The IPL program on the TCP/IP board starts.
Input 3 sets of 3-digit decimal numbers through the keyboard of
the ECR and press the ENTER key.
Following the SHARP maker code (08, 00, 1F), the 3 sets of
numbers input through the keyboard are converted into hexadeci-
mal numbers. The program then writes a total of 6 bytes MAC
address into dual port RAM (800000H - ).
Turn off the power supply and remove the TCP/IP board from the
ECR.
Remove EPROM from the TCP/IP board and turn the IPL switch
to the "normal mode."
Connect the board to the ECR and turn on the ECR.
Displayed when an
error occurs.
Displayed when an
error occurs.
Data of 6 bytes is
displayed.
10 digits are
displayed.
Input : DUAL PORT RAM (800000H')
08 00 1F XX YY ZZ
MAC ADDRESS (XX, YY, ZZ are converted to 16 hexadecimal
numbers.)
Output : DUAL PORT RAM(800800H')
During writing
I P L 0 0 0
When writing is completed(The same applies when copy is
skipped at the first verification.)
I P L 0 0 0
When writing process ends with an error.
I P L 0 0 0
Display
MAC ADDR&FIRM Write
MAC ADDRESS
AAA BBB CCC
08 00 1F XX YY ZZ
TCP/IP FIRM CHANGE
IPL 00-07 XX (XX : 00~07 OK or NG)
TCP/IP FIRM CHANGE :
ERASE 00-07 00
A
B COPY 00-05 00
C FIRM CHANGE PASS!!
While the address and firmware are being rewritten, the message
A and then B appears.
When the address and firmware have been rewritten, the mes-
sage C is displayed.
The following screen appears when the IPL switch is not turned to
the write mode.
MAC ADDR&FIRM Write
CHANGE IPL SW!!
How to exit the program.
Press the CANCEL key to exit the program.
After rewriting, make sure to turn the power off and then turn it
on again.
7 0 0
7 O K
7 N G
Decimal numbers are
input through
keyboard.
Data of 6 bytes is
displayed as
hexadecimal numbers