Table of Contents
Advertisement
Wall mounting
To mount the device, perform the following steps:
Fig. 5:
Mounting and connecting the wall bracket
Technical Reference Manual 1473-1-8811
Connection, installation / mounting
1. Fix the wall bracket [7] to the wall
with the supplied screws [5] and
washers [3].
–
The washers are necessary for
obtaining protection type IP44.
2. Connection of the integrated
free@home bus coupler according to
connecting diagram:
–
Feed the free@home bus line
through the rubber seal / cable
screw gland [4] in the wall
bracket.
–
Connect the free@home bus line
to the 2-pole bus connecting
terminal [2] in the wall bracket.
Observe the correct polarity!
3. Connecting the optional rain sensor
with heating:
–
Feed the 230 V line through the
rubber seal / cable screw gland in
the wall bracket.
–
Connect the 230 V line to the
connecting terminal [1] in the wall
bracket.
Operation is possible also without mains
voltage. However, the rain sensor
heating does not function then.
│14
Advertisement
Table of Contents
