Canon VB-S30D Operating Manual page 63

(8) [Day/Night Mode Switching]
Select the Day/Night Mode switching behavior when a
timer event is triggered.
Select [Switch to Day Mode] to switch to Day Mode at
the start time, and Night Mode at the end time.
Select [Switch to Night Mode] to switch to Night Mode
at the start time, and Day Mode at the end time.
Select [Disable] to disable Day/Night Mode switching.
Important
• [Day/Night Mode Switching] can only be set in [Timer 1].
• [External Device Output] and [Day/Night Mode Switching] do
not support [Repeat Interval].
• When [Day/Night] in the Admin Viewer is set to [Auto], Day/
Night Mode switching will not happen when a timer event is
triggered (p. 144).
• If the [Day/Night Mode Switching] settings switch Day/Night
Mode while the Admin Viewer/VB Viewer is assigned camera
control, control will be released.
Note
When using timers that run continuously for 24 hours with a
[Repeat Interval] of 30 seconds or less, set the timer start and
end times so the timers can run continuously.
Example:
Timer [Start Time] [End Time]
[Timer 1] 0:00 12:00
[Timer 2] 12:00 0:00
[Event] Setting Video Record, Volume Detection, External Device Output/Input and Timer
[Repeat Interval]
10 sec
10 sec
3
63