Mitsubishi Electric PAR-WT40R-E Installation And Setting Manual page 8

Place the electrical box back in the original position and reinstall the two screws.
Check the maximum reach of the cable and
install the bracket on the wall with screws.
Do not excessively pull the cable when
checking the maximum reach.
<Notice>
● Do not overtighten the screws.
►The bracket may deform or break.
● When installing the bracket, select an interference-free space.
►Keep the installing area at least 10 cm away from metal or a wall box. If unable to do
so, always place the room wireless remote controllers in locations where the com-
munication test determines that the wireless remote controllers are fully capable of
communication with the wireless receiver.
● Do not install the bracket with screws on the exterior casing of the cylinder unit.
►The internal parts may be damaged, which could result in breakdown of the indoor
unit.
Place the wireless receiver on the fixed brack-
et.
Hook the holes on the back of the wireless re-
ceiver onto the projections on the bracket, and
fix the wireless receiver in place.
<Notice>
● Do not place the wireless receiver inside the cylinder unit.
►Both the wireless receiver and the indoor unit may break down, produce heat, and
the wires may break.
● Do not let the wireless receiver stand on top of the cylinder unit. Always fix the
wireless receiver onto the bracket.
►Wireless communication performance may be affected.
● Do not pull the cable excessively.
►Breakdown, ignition, or fire may result.
● Do not leave the wireless receiver suspended.
►Breakdown, ignition, or fire may result.
Close the electrical box cover, and fix it with screws.
Fix the front panel and the handle with screws.
If the relay connector on the main controller has been removed, connect the relay
connector again before reinstalling the front panel.
7