Miele GAS COMBISET CS 1011 Operating And Installation Instructions page 19

Burner
The burner can be dismantled and
cleaned when cool.
^ Remove the burner parts and wash
them in a solution of hot water and
liquid dish soap. Dry them
thoroughly. Make sure that the flame
holes are clean and completely dry.
^ Wipe the burner base clean with a
damp cloth and then dry.
^ Gently wipe the ignitor and ignition
safety control with a slightly damp
cloth, and then wipe dry.
Make sure that no liquid gets into
the appliance.
Cleaning and care
Reassembling the burner
After cleaning the burner reassemble in
the correct order:
^ Place the burner head j onto the
burner base m, making sure that the
thermocouple k and ignitor l align
through the holes in the burner head.
The notch on the burner cap must
securely fit into the recess of the
burner .
The notch on the burner must
securely fit into the recess in the
lower part of the burner base
^ Fit the burner ring i.
^ Seat the burner caps g and h into
place.
^ Put the grates in place.
Be careful not to mix up the parts.
.
19