D-Link DVG-6004S User Manual page 28

DVG-6004S/6008S User's Manual
FAX/Modem: Enable this line to detect if there is a fax tone and transfer the call to a fax line.
NOTE: When a fax tone is detected from the call, the gateway will automatically switch from
voice mode to fax mode. Hence, the fax settings will be temporarily applied to a specific port
which detects the fax tones, instead of its default voice settings.
Trunk Hunting Order: To set FXO dial-out mode when there is an incoming call dialed FXO
representative number.
First Idle: The gateway will assign each unassigned call from first FXO line.
Sequential: The gateway will automatically assign the first unassigned call to the first FXO line. The
second FXO line will dial the second unassigned call out. Each line will be used.
D-Link Systems, Inc.
This Manual: http://www.manuallib.com/file/2602385
Function Fax Detection Content of SDP of re-INVITE
Disable No
T.38 Fax Yes
T.30 Fax Yes
T.30 Detect CED
Fax/Modem only
T.30 Only No
T.38 Native Yes
N/A
re-INVITE with T.38 and T.30
re-INVITE with T.30
re-INVITE with T.30
N/A(All the calls use T.30
codec of RTP stream, not
need to change codec.)
re-INVITE with T.38
Telephony Settings
Receive re-INVITE with T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
Accept and change RTP to T.38
23