4-4
4.4
Power-Up Self-Check Errors
Each time the radio is turned on, the MCU and DSP perform a series of internal diagnostics. These
diagnostics consist of checking such programmable devices as the FLASH ROMs, the EEPROM,
and SRAM devices.
Problems detected during the power-up self-check routines are presented as error codes on the
radio's display. For non-display radios, the problem is presented at power up by a single, low-
frequency tone.
recommended corrective action.
Error
Code
01/02
FLASH ROM Codeplug Checksum Non-Fatal Error
01/12
Security Partition Checksum Non-Fatal Error
01/20
ABACUS Tune Failure Non-Fatal Error
01/22
Tuning Codeplug Checksum Non-Fatal Error
01/81
Host ROM Checksum Fatal Error
01/82
FLASH ROM Codeplug Checksum Fatal Error
01/88
External RAM Fatal Error – Note: Not a checksum failure
01/90
General Hardware Failure Fatal Error
01/92
Security Partition Checksum Fatal Error
01/93
FLASHport Authentication Code Failure
01/98
Internal RAM Fail Fatal Error
01/A2
Tuning Codeplug Checksum Fatal Error
02/81
DSP ROM Checksum Fatal Error
02/88
DSP RAM Fatal Error – Note: Not a checksum failure
02/90
General DSP Hardware Failure (DSP startup message not
received correctly)
09/10
Secure Hardware Error
09/90
Secure Hardware Fatal Error
Note: If the corrective action does not fix the failure, send the radio to the depot.
Table 4-4
lists possible error codes, a description of each error code, and a
Table 4-4. Power-Up Self-Check Error Codes
Description
Troubleshooting Procedures: Power-Up Self-Check Errors
Reprogram the codeplug
Send radio to depot
Turn the radio off, then on
Send radio to depot
Send radio to depot
Reprogram the codeplug
Send radio to depot
Turn the radio off, then on
Send radio to depot
Send radio to depot
Send radio to depot
Send radio to depot
Send radio to depot
Turn the radio off, then on
Turn the radio off, then on
Turn the radio off, then on
Turn the radio off, then on
Corrective Action