Table of Contents
Advertisement
Rack Assembly
Do not use the blade assembly unit in any unapproved place.
Install the blade assembly unit on a standard EIA 19-inch rack assembly. Do
not install the rack containing the blade assembly unit in a place inappropriate
to the rack installation environment.
Failure to follow these instructions may cause some bad influences to be
imposed on the blade assembly unit and the other systems installed on the
rack. Fire or personal injury may also occur if the rack should fall. For detailed
explanations on the place where the blade assembly unit should be installed, as
well as earthquake-resistant construction for the rack, refer to the manual
attached to the rack or contact your service representative.
Always install the blade assembly unit on a rack conforming to the relevant
standard.
Install the blade assembly unit on a 19-inch rack conforming to the EIA
standard. Do not use the blade assembly unit with installed on any other rack or
without the installation on a proper rack. Failure to follow these instructions may
cause the blade assembly unit to operate incorrectly and/or personal injury or
damages of surrounding devices to occur. Contact your service representative
for the racks available for the blade assembly unit.
Do not carry or install the blade assembly unit by yourself.
More than one person is required to carry or install the rack. Failure to follow
this instruction may cause the rack to fall, resulting in personal injuries and/or
breakage of surrounding devices. In particular, a high rack (such as 44U rack)
is unstable if it is not fixed by stabilizers. The rack must always be carried or
supported by more than one person.
Do not install the blade assembly unit in such a way that the load is
concentrated on a specific point.
Install stabilizers on the rack so that the total load of the rack and devices
mounted on the rack is not concentrated on a single point or attach several
racks to distribute the load. Failure to follow this instruction may cause the rack
to fall, resulting in personal injury.
Do not install components on the blade assembly unit by yourself.
More than one person is required to install components, including the doors and
trays for the rack. Failure to follow this instruction may cause some parts to fall,
to be broken and/or to result in personal injury.
WARNING
CAUTION
7
Advertisement
Table of Contents
