Electrolux 6000 series Service Manual page 23

4. Using two or more people, carefully lift the dryer onto
the pedestal, tilting the dryer back slightly to engage
the slots in the rear of the dryer with the tabs of the
rear brackets on the pedestal. See Pictures 12 and
13.
Picture 12
Picture 13
5. Set the dryer down onto the pedestal making sure
the service panel bracket on the dryer is behind the
front brackets of the pedestal. See Picture 14.
Picture 14
6. With the pedestal drawer open for better access, install
two #10 screws through the front brackets in the
pedestal into the service panel bracket of the dryer
as shown in Picture 15.
Picture 15
7. After closing the pedestal drawer, carefully move the
dryer/pedestal assembly in to position.
NOTE: Because of the increased weight caused
by the addition of the pedestal, two or more
people may be required.
9. Excessive noise and vibration can be prevented
by properly leveling the dryer/pedestal assembly
on a SOLID floor and tightening the leveling leg
lock nuts.
With the dryer/pedestal assembly in its' final position,
place a level on top of the dryer.
Adjust the pedestal leveling legs so the dryer/pedestal
assembly is level front-to-rear and side-to side, and
stable corner-to-corner.
Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropiate leg
so the dryer/pedestal assembly is SOLID on the floor
on ALL four pedestal legs.
After leveling the dryer/pedestal assembly, adjust the
lock nut on each pedestal leveling leg against the
pedestal base and tighten with a wrench. Keep the
leg extension at a minimum to prevent excessive
vibration.
10.Refer to the Installation Instructions that came w i t h
the dryer to properly complete electrical and venting
connections. If questions arise, please refer to the
Owner's Guide that came with the dryer for contact
information.
23