GE 14 Owner's Manual page 12

About storage drawer and cover removal.
Not all features are on all models.
Drawer and Cover Removal
12
Drawers will stop before coming all the way out of the refrigerator to
help prevent contents from spilling onto the floor. These drawers
can be removed easily by grasping the sides and lifting up slightly
while pulling drawers past the stop location.
Full-Width Drawer with Plastic Cover
To remove the cover, lift it off its supports, pull it
forward, tilt it and take it out.
Twin Drawer With Glass Cover
To remove:
Remove the drawers.
1
Reach in, push the front of glass cover up and, at the
2
same time, pull it forward as far as it will come.
Tilt it and take it out. Avoid cleaning the cold glass cover
with hot water because the extreme temperature
difference may cause it to break.
Remove the drawer frame. (Always remove the glass
3
cover before you take out the drawer frame.)
Lift the frame off the supports at each side and back,
pull it forward, tilt it and take it out.
To replace:
Lower the frame until it rests on the supports at each
1
side and back.
Replace the glass cover, pushing its rear edge firmly
2
into the rear frame channel and gently lowering the
front into place.
Replace the drawers.
3