ATA Voice Field Reference
Regional page
Cisco Small Business ATA Administration Guide
Ring7 Name
Ring8 Name
Ring9 Name
Ring and Call Waiting Tone Spec section
IMPORTANT: Ring and Call Waiting tones dont work the same way on all phones.
When setting ring tones, consider the following recommendations:
Begin with the default Ring Waveform, Ring Frequency, and Ring Voltage.
If your ring cadence doesnt sound right, or your phone doesnt ring, change
your Ring Waveform, Ring Frequency, and Ring Voltage to the following:
-
Ring Waveform: Sinusoid
-
Ring Frequency: 25
-
Ring Voltage: 80V
Field
Ring Waveform
Ring Frequency
Ring Voltage
Name in an INVITEs Alert-Info Header to pick distinctive
ring/CWT 7 for the inbound call.
The default is Bellcore-r7 .
Name in an INVITEs Alert-Info Header to pick distinctive
ring/CWT 8 for the inbound call.
The default is Bellcore-r8 .
Name in an INVITEs Alert-Info Header to pick distinctive
ring/CWT 9 for the inbound call. This field is for the
SPA2102 only.
The default is Bellcore-r9 .
Description
Waveform for the ringing signal. Choices are Sinusoid or
Trapezoid. The default is Trapezoid.
Frequency of the ringing signal. Valid values are 10100
(Hz). The default is 20.
Ringing voltage. Choices are 6090 (V). The default is 85.
B
140