T12Fg → Fx-32 Model Data Conversion - ROBBE-Futaba FX-32 Instruction Manual

FX-30/T12FG →FX-32 MODEL DATA CONVERSION
The model data (only latest version) of FX-30/T12FG can be copied to FX-32.
* The card reader of a personal computer, SD card, and CF card is required.
* The model data of FX-32 cannot be copied to FX-30/T12FG.
[Model data conversion method]
1. Attach a SD card that contains model data of
T12FG or FX-30 to the SD slot of a FX-32.
2. Turn on the power switch, and the Data
Converter should run.
3. The converter shows a list of model data in the
card. Select a model data that you want to
convert and push "RTN" key, and the converter
should begin converting data.
4. If the convert succeeds, the converter will show
the following message. The converted data
are copied to the internal memory of the FX-32.
Hence, if the FX-32 does not have free spaces
of its internal memory, converts must fail.
5. The converter can accept model data made
by T12FG or FX-30 with the latest software
(Ver.3.0) only. If you try to convert model data
made by old version software, the converter
must fail to convert and show the following
error message. If this message is shown, do the
following procedure to update the model data
in order to avoid this limitation.
(a) First, update a T12FG or FX-30 to the latest software (Ver. 3.0).
(b) Load the model data failed to convert into the T12FG or FX-30 with
the latest software, and the model data should be updated to the latest
format.
(c) Save the updated model data to a SD card.
(d) Retry to convert the updated model data on a FX-32.
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
* When SD card cannot be recognized, it may be able to be used
if it reformats by SD formatter offered from SD Association.
SD formatter is downloadable from SD Association (https://www.
sdcard.org/).
(As of January, 2013)
CAUTION
After the completion of a data copy should fully
perform a check of operation on the model to be
used.
Check well all the directions of operation and all
the operation switches.
Compulsive reset of data *Usually, it is not used.
Operation will become unusual if imperfect model
data should be read.
In that case, the forcible reset of the model data can
be carried out by the following method.
[Model data compulsive reset method]
1. First, "HOME/Exit" and "U.menu/Mon" are pushed.
The power supply of FX-32 is then turned on.
2. A "INITIALIZE DATE" screen comes out. "RTN" will
be pushed if forcible reset is carried out. In a
stop, a power supply is turned off.
©FUTABA CORPORATION 2013, 3 (1)
<Data> 175