Accessing The Cli - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference
If the help output shows a parameter in angle brackets, you must replace the parameter with a value.
(UBNT EdgeSwitch) #network parms ?
<ipaddr> Enter the IP Address.
none Reset IP address and gateway on management interface
If there are no additional command keywords or parameters, or if additional parameters are optional, the
following message appears in the output:
<cr> Press Enter to execute the command
You can also enter a question mark (?) after typing one or more characters of a word to list the available
command or parameters that begin with the letters, as shown in the following example:
(UBNT EdgeSwitch) #show m?
mac mac-addr-table
mail-server mbuf

Accessing the CLI

After you have connected the EdgeSwitch to your network, you can access the CLI using a telnet or SSH
connection from a remote management host.
For on how to connect the switch to your network, refer to the Quick Start Guide that came with the
EdgeSwitch.
Ubiquiti Networks, Inc.
Using the Command Line Interface
mac-address-table
monitor
36