Troubleshooting Guide - AGA marvel 6SDZE Operating And Maintenance Instructions Manual

Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact a qualified service technician.
Electrocution Hazard
Never attempt to repair or perform maintenance on the
unit until the main electrical power has been disconnected.
Turning the unit control "OFF" does not remove electrical
power from the units wiring.
Problem
Unit not cold enough.
Adjust temperatures (See
"Changing Current Set-
tings" on page 6).
Unit too cold.
Adjust temperatures (See
"Changing Current Set-
tings" on page 6).
No interior light inside
cabinet.
Light will not go out when
door is closed.
Noise or Vibration.
Unit will not run.
TROUBLESHOOTING YOUR WINE CELLAR
Possible Cause
• Control set too warm.
• Content temperature not stabilized.
• Excessive usage or prolonged door
openings.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Control set too cold.
• Door gasket not sealing properly.
• Bulb burned out.
• Door not activating light switch.
• Display light function has been activated.
• Unit not level
• Unit turned off
• Power cord not plugged in.
• No power at outlet.
• Adjust temperature colder. Allow 24
hours for temperature to stabilize.
• Allow temperature to stabilize for at least
24 hours, with minimal door openings.
• Airflow must not be obstructed to front
grille. See "clearances" on page 4.
• Check door alignment and/or adjust or
replace door gasket.
• Adjust temperature warmer. (See page
6, "set the desired temperature"). Allow
24 hours for temperature to stabilize.
• Check door alignment and/or adjust or
replace door gasket.
• See "Care and Cleaning" page 16 or
contact a qualified Aga Marvel service
representative.
• Verify cabinet is level, refer to page 4 for
leveling instructions.
• Verify the door is aligned properly, refer
to page 11 for instructions.
• Turn off display lighting.
• Level unit, see "Leveling Legs" on page
4.
• Turn unit on. See "Start your Appliance"
on page 6.
• Plug in power cord.
• Check house circuit.
17
Remedy