Table of Contents
Advertisement
XI. BASIC TROUBLESHOOTING
The diagnostic flash codes for your scooter are designed to help you perform basic
troubleshooting quickly and easily. A diagnostic flash code can be displayed in one of
two ways:
A light labeled "Diagnostic" on the control panel will flash
The battery indicator light farthest to the left on the battery gauge (red light)
will flash
Please refer to the diagram below for flash codes, description of problem, and
recommended actions.
Flash Code
Description
1
Low Battery Voltage
2
Motor Disconnect
3
Motor Wiring Trip
4
Freewheel Trip
5
N/A
6
Charger Inhibit
7
Throttle Trip
8
Controller Trip
9
Brake Trip
10
High Battery Voltage Check battery connections
Once the recommended action is taken, turn the scooter off and then back on again to
clear the flash code. If the problem was not corrected, or another problem exists the
controller may display another flash code.
ATTENTION – Your scooter may have a diagnostic light on the tiller that
will stay on constantly. The light will begin to flash when you have a
serviceable item.
A
Bobcat X Owner's Manual
OR
Recommended Action
Charge battery
Disconnect & Reconnect front and rear section
Check motor connections
Place the scooter in "drive" mode
N/A
Disconnect the charger
Place throttle in neutral position
Check connections at controller
Place the scooter in "drive" mode
32
www.drivemedical.com
REV.1.03.07.14
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Bobcat X3 and is the answer not in the manual?
Questions and answers
red light flashing 3 followed by 2, then repeats
A red light flashing 3 times followed by 2 times on a Drive Bobcat X3 indicates two separate flash codes:
- Flash Code 3: Motor Wiring Trip – Check motor connections.
- Flash Code 2: Motor Disconnect – Disconnect and reconnect the front and rear section.
After performing the recommended actions, turn the scooter off and back on to clear the codes. If the problem persists, another issue may be present.
This answer is automatically generated