Water Filter - Kenmore 795.7132 Series Use & Care Manual

WATER FILTER

It is recommended that you replace the water
• Approximately every 6 months.
• When the water
turns on.
• When the water dispenser output
decreases.
• When the ice cubes are smaller
than normal.
1. Remove the old water filter.
• Lower or remove the top left
shelf to allow the water
rotate all the way down.
• Press the push button to open the
water cover.
NOTE: Replacing the water
causes a small amount of water
(around 1 oz. or 25 cc) to drain.
Before pushing the button to open the
water cover, place a cup under
the front end of the cover to collect
any leaking water. Hold the water
upright, once it is removed, to
prevent any remaining water from
spilling out of the water
• Pull the water downward
and pull out. Make sure to rotate
the down completely before
pulling it out of the manifold
hole.
• Take the new water
remove the protective cover from the o-rings. With
water tabs in the horizontal position, push the new
water into the manifold hole until it stops.
indicator
to
out of its packaging and
WATER FILTER
• Rotate the water
position and close the cover.
The cover will click when closed
correctly.
3. After the water
gallons of water
to remove trapped air and contaminates from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
4. Water Filter Bypass Plug
Keep the water
bypass plug. You MUST
use the water
bypass plug when a
replacement water
cartridge is not available.
CAUTION: DO NOT operate refrigerator without
water
NOTE: To purchase a replacement water
Sears store or call 1-800-4-MY-HOME
order on-line at www.sears.com/partsdirect
26
up into
is replaced, dispense 2.5
for approximately 5 minutes)
or water plug installed.
Water Filter
Bypass Plug
visit a
® . Also, you may