To Operate Forward/Reverse Switch; To Insert/Remove Bits; Operating Instructions - Drill Master 96526 Set Up And Operating Instructions Manual

Read the EntIRE IMpORtAnt SAFEtY InFORMAtIOn section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
1. The three-position Forward/Reverse Switch (7) is located on top of the Power
Switch (10). (See Figure C.)
2. When the Forward/Reverse Switch (7) is in the center, the Drill/Driver is in a
"LOCKeD" position. (See Figure C.)
3. When the Forward/Reverse Switch (7) is pressed to the right, the rotation of the
Drill/Driver will be clockwise (typically for driving fasteners or drilling holes). (See
Figure C.)
4. When the Forward/Reverse Switch (7) is pressed to the left, the rotation of the
Drill/Driver will be counterclockwise (typically for removing fasteners or freeing
drill bits). (See Figure C.)
to Insert And Remove Drill And Screw Driver Bits
1. Set the Forward/Reverse Switch (7) to the "LOCKeD" (center) position.
(See Figure C.)
pOWER SWItCH (10)
2. The Drill/Driver is equipped with a Keyless Chuck (1). To insert and remove drill
bits or screw drivers, loosen the Chuck. (See Figure D.)
SKU 96526 For technical questions, please call 1-800-444-3353.

OpERAtIng InStRuCtIOnS

to Operate the Forward/Reverse Switch
FORWARD/REVERSE SWItCH (7)
FIguRE C
Page 11