Brother P-Touch PT-E300 User Manual page 52

TROUBLESHOOTING
Message
Memory Full!
Check # of
Digits
Entered!
Input A,B,C or D
At Start&End!
Maximum Of
5 Bar Codes
Per Label!
Text
Too High!
Installed tape
is not compatible
with this machine!
System Error XX
Select Other
Cut Option!
Line Limit!
Max 100 Lines
per Label
Block Function
is Not Allowed!
Line Limit!
Max 2 Lines
This Function
Requires 9mm
or Wider Tape!
Sequence Type
Must be None
When Editing!
Cassette Type
Does Not Match.
Continue?
49
Error Messages
There is not enough internal memory available when you try to save a label
file. Delete any unnecessary files to make more memory available for the
new label file.
The number of digits entered in the bar code data does not match the
number of digits set in the bar code parameters. Enter the correct number
of digits.
The bar code data entered does not have the required start/stop code (A,
B, C, or D required at the beginning and end of the bar code data for the
CODABAR protocol). Enter the bar code data correctly.
There are already five bar codes entered in the text data when you try to
enter a new bar code. You can only use up to five bar codes in each label.
You can enter up to two bar codes when (AA|AA) is selected in flag layout.
The text size is too large. Select a different size option.
Installed tape is incompatible with this labelling system. Use compatible
tape.
Please contact Brother customer service.
The tape length set using the tape length setting is shorter than the total
length of the left and right margins applied for the "Large Margin" cutting
option. You have to select a different cutting option.
Exceeds max. You can enter up to 100 lines in the whole page and blocks.
In this setting, you cannot add or delete blocks.
PUNCH-DOWN BLOCK layout allows to print up to 2 lines / block.
PUNCH-DOWN BLOCK layout must use 9 mm or wider tape cassettes.
Texts cannot be edited when you set Sequence Type in PUNCH-DOWN
BLOCK to Horizontal or Backbone.
For example, Heat Shrink Tube cartridge is detected but Heat Shrink Tube
mode is not selected, or Heat Shrink Tube mode is selected but the Heat
Shrink Tube cartridge is not inserted into the P-touch labelling system.
Cause/Remedy