Troubleshooting - Luma Comfort IMPC-2800S Owner's Manual

Troubleshooting

Problem
The "ADD WATER" indicator
light is on.
The "FULL ICE" indicator is
on.
The large reservoir is full of
water, but the "ADD WATER"
indicator is always on.
Water does not flow out from
the water separator pipes.
There is no water in the unit,
but the "ADD WATER"
indicator light is not on.
The ice cubes being produced
are thin and break easily.
The ice making cycle is
starting but no ice is being
made.
Possible Cause(s):
There is not enough water in the
water reservoir.
There is too much ice in the
machine.
The water in the tank may be
distilled.
The water filter located on the
bottom of the water reservoir is
blocked, preventing water from
entering the lower tank.
The openings in the water
separator pipes may be blocked.
The water in the tank may have
impurities.
The wall of the lower tank located
underneath the ice basket is
dirty.
The ambient temperature is too
high.
The ambient temperature or the
water temperature in the inner
tank is too high.
The refrigerant is leaking.
The pipe in the cooling system is
blocked.
Solution(s):
Turn off the ice maker, fill it with
water and press the "ON/OFF"
button again to restart the unit.
Remove ice from the ice basket.
Use tap or mineral water in the
tank.
Clean the water filter.
Use a pin to prick each pipe
opening until water can easily
flow through.
Use normal drinking or tap water
in the unit.
Clean this water tank.
Turn off the unit first and
press/hold the "ON/OFF" button
for more than 5 seconds to turn
on the unit again. This will
lengthen each ice making cycle
and make thicker ice cubes.
Move the ice maker to an area
with an ambient temperature
under 90°F and pour cooler
water into the tank.
Consult a technician.
Consult a technician.
6