Downloading An Image Or Boot Code File Using Xmodem - Cisco SG200 Series Administration Manual

Administration
File Management
STEP 5
STEP 6
STEP 7
STEP 1
STEP 2
Cisco Small Business SG200 Series 8-port Smart Switch
Enter the command to have an IP address assigned to the port from a DHCP server
on the attached network:
CFE> ifconfig eth0 -auto
When the switch receives a DHCP reply, the IP information displays on the
terminal.
Enter the command to download an image file to Flash:
CFE>flash server-ipaddr:image-filename flash0.os
Or, enter the command to download a boot code file:
CFE> flash ipaddr:bootcode-filename flash0.boot
Replace ipaddr with the IP address of the system where the file resides, and
replace image-filename or bootcode-filename with the actual image or
boot code filename.
WARNING! Make sure that the switch is connected to an uninterrupted power
supply during a boot code upgrade. This process might take 10–20 seconds.
When the download is complete, the switch copies the image or boot code file
into Flash memory.
Enter the command to restart the switch to boot it with new software:
CFE>reset -sysreset
NOTE: You can verify the boot code or image version by viewing the System
Summary page in the web-based switch configuration utility. Or, from the
command line interface, you can enter the show sysinfo command.

Downloading an Image or Boot Code File Using XMODEM

To download a software image or boot code file using XMODEM at the boot
prompt:
Using a terminal emulation program, open a serial connection between the switch
and the management system connected to the switch console port.
Power up the switch.
3
72