Error Messages - Zoom Handy recorder H2 Operation Manual

Card related messages
No Card
No File
Card Format Error!
Card Full!
File name exists!
Stop Recorder!
Card Protected
Format Card?
Now Recording!
File Create Error!
Card Error!
File Protected
File Rename Error!
Card Write Error
Card Read Error!
Data Write Error
* If card related error messages occur frequently, the SD card may be defective.
Other messages
RESET DATE/TIME
Low Battery!
Please Power Off
Please pull out external input
Only Built-in MIC is active
Invalid File!
89

Error Messages

Cause
No SD card is inserted.
A valid file was not found.
SD card formatting process failed, or card
was not recognized normally.
Card became full during recording
File name change was attempted, but file
with same name already exists.
User attempted to access a menu not
available during playback or recording.
The SD card is write-protected.
SD card with incorrect format was inserted.
User attempted to access a menu not
available during recording or recording
standby.
The file could not be created at start of
recording.
A card error has occurred.
User attempted to write to a read-only file
from the file menu.
A blank or invalid file name was specified
during file name editing.
Shown when an error occurs during file
write other than recording.
Shown when an error occurs when opening a
file.
Shown when data transfer to SD card cannot
keep up with data stream during recording.
Cause
The internal clock was reset because battery
backup was interrupted.
Battery voltage is low.
Shutdown procedure is complete.
When external mic or component is
connected, mic pattern cannot be selected.
External mic or component is connected,
although only built-in mic is active in 4-
channel mode.
An invalid file was specified.
Remedy
Insert SD card and turn power on.
*
Specify a different file name.
Stop the recorder operation first.
Change setting of card's write-
protect switch.
When you select "YES" at this
5
screen and then press the
key, all data are erased and
initialization is carried out.
Stop recording first.
*
Change the read-only file attribute
using a computer.
Do not use invalid characters.
*
Reduce sampling frequency and/or
number of bits.
Remedy
Set the date and time again. The
internal clock requires batteries to be
inserted.
Replace batteries.
Set power switch to OFF.
Disconnect any external mic or
component connected to [EXT MIC
IN] or [LINE IN] jack.
Select a valid file.
ZOOM H2
(REC)