Troubleshooting; Parts And Servicing - Clarke Power IG2200 Operation & Maintenance Instructions Manual

TROUBLESHOOTING

PROBLEM
The generator fails
to start
The generator fails
to generate
electricity
The generator is
difficult to start
If this does not solve your problem, please contact the Clarke service
department. see below.

PARTS AND SERVICING

For Parts & Servicing, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CAUSE
Engine switch is off
Not enough oil in the
generator
No fuel
Spark plug not working
correctly
The device you are trying to
power is faulty
The overload indicator is on
(DC supply only) The DC
Overload protector has
activated.
The air filter is dirty
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: Parts@clarkeinternational.com
SERVICE: Service@clarkeinternational.com
SOLUTION
Set the engine switch to 'on'
Add more oil, See page 10
Add more fuel, See page 11
Change the spark plug, See
page 20
Make sure the device you want to
power is working properly
Remove the appliance
immediately, do not connect any
appliance that requires more than
2.2 KVA.
Press the reset button. See page 16
Clean the air filter. See page 19
22