Subscribe to Our Youtube Channel
Summary of Contents for VuWall VuStream 150
- Page 1 VuStream 150 Single Channel Encoder/Decoder User Guide December 2022 www.vuwall.com © 2022 - VuWall Technology, Inc. Simplicity in AV networks & Video Wall management...
-
Page 2: Table Of Contents
Viewing the stream ....................16 Viewing stream in VLC Media Player ..............16 Viewing multicast stream using VLC Media Player ..........17 Configuring the VuStream 150 encoder in TRx ............. 18 Configuring the VuStream 150 encoder in VuWall2 ..........19 Specifications ....................... 20 Contact Information .................... -
Page 3: Introduction
The VuStream 150 is an encoder and decoder in a single device. It can transmit HDMI 2.0 signals up to 2160p60 resolution over standard networks using H.264 & H.265 streams, either unicast or multicast to a VuStream 150 decoder, VuScape controller decoding cards or to standard players like VLC. -
Page 4: Device Overview
VuStream 150 – User Guide Device overview Front view: USB3.0 connector to record input in various formats. LED power on/off indicator. Rear view: Number Name Function description HDMI IN Connect to HDMI source (PC, Media Player, Laptop) LINE IN 3.5mm stereo analog audio input HDMI OUT HDMI2.0 loop out port, connect to local HDMI display... -
Page 5: Connecting To The Device
The VuStream 150 device can be configured over a Web GUI with a browser. To configure the device via an existing network switch you will need the following components: ✓... -
Page 6: Connecting To The Device Via Point-To-Point
VuStream 150 – User Guide Connecting to the device via point-to-point Use this alternative way if there is no DHCP server in place at the time of setup, or if a very limited number of devices need to be configured. -
Page 7: Network
VuStream 150 – User Guide Network Here you can adjust the network settings for the device. DHCP: Enable/disable DHCP Static IP: Setting static IP Subnet Mask: Setting subnet mask Default Gateway: Setting default gateway Primary DNS: Setting primary DNS Secondary DNS:... -
Page 8: Source
VuStream 150 – User Guide Source This page contains input signal status, input Video Source and Audio Source selection. Users can change input video property, source and check input video information here. Brightness, Contrast, Hue and Saturation only available with Hardware Version 2.0 Video source: Set the video source to HDMI if the device is used as encoder. -
Page 9: Encoder
Encoder page contains Main Encoder and Sub Encoder, which allows user to change video and audio encode settings. If the VuStream 150 is used as decoder you can skip this part. Sub Encoder only available with Hardware Version 2.0 If Main Encoder and Sub Encoder are used at the same time, the limitation is as follows: Main Encoder: 3840x2160 60Hz –... -
Page 10: Recording
Recording Record page allows user to change the video format that recorded to USB3.0 (front) disk drive. Recording is only available when VuStream 150 device is used as encoder. Sub Record only available with Hardware Version 2.0 The following Main Recording settings can be adjusted: Encoder source: Select encoder. -
Page 11: Streaming
VuStream 150 – User Guide Streaming Contains Main Streaming and Sub Streaming, which allows user to change streaming type settings. Sub Streaming only available with Hardware Version 2.0 Encoder Source: Select main encoder. Auto Stream: To start the stream automatically when an HDMI input source is detected. - Page 12 VuStream 150 – User Guide SRT Streaming Type settings When SRT is set as caller this setting can be adjusted: SRT Port, Caller IP Address (xxxxx), Latency (20-8000ms) and Passphrase (Letters and/or numbers). When SRT is set as listener this setting can be adjusted: SRT Port and Passphrase (Letters and/or numbers).
-
Page 13: Monitor
VuStream 150 – User Guide Monitor HDMI Output and Line-Out settings can be adjusted at this menu. HDMI out: Resolution: 1600x1200, 1920x1080, 1920x1200, 2560x1080, 2560x1440, 3440x1440, 3840x1600 and 3840x2160 Default Resolution: 1920x1080 Framerate: 30 or 60 Volume: 0 – 255... -
Page 14: System
VuStream 150 – User Guide System In system page, user can set device name, disk format system recovery and firmware update. Device name setting: User can set device and channel name here. Storage Info: User can format attached USB disk drive here, supported formats are listed as below. -
Page 15: Status
VuStream 150 – User Guide Status User can check the VuStream 150 device status here (Including input signal, streaming status). © 2019 VuWall Technology, Inc. -
Page 16: Viewing The Stream
VuStream 150 – User Guide Viewing the stream Use this URL format to access the stream: • MainStream: rtsp://username:password@<IP Address>:554/S1 See following tips on how to use these URL in VLC Media Player, TRx and VuWall2. Viewing stream in VLC Media Player 9) Generated streams from the encoder can be viewed with VLC media player. -
Page 17: Viewing Multicast Stream Using Vlc Media Player
VuStream 150 – User Guide 13) To check for detailed information of the stream, you can select in the VLC menu “Tools” -> “Codec Information” Viewing multicast stream using VLC Media Player By default, you will view a unicast stream session in VLC. If you wish to benefit of multicast to effectively distribute the stream to multiple viewing endpoints on the network. -
Page 18: Configuring The Vustream 150 Encoder In Trx
VuStream 150 – User Guide Configuring the VuStream 150 encoder in TRx 1) Enter the TRx Configuration mode and create a device into a zone. 2) Press the 3 dots on the top right corner of the device and select “Associate / Configure”. -
Page 19: Configuring The Vustream 150 Encoder In Vuwall2
1) Open the VuWall2 Client and connect to the VuWall2 server 2) Navigate left to "IP Devices" and right click in the free area. 3) Select "Create New IP Device" and enter a name. 4) Enter the streaming address of the VuStream 150 into the field. E.g.t: rtsp://admin:vuwall@192.168.30.150:554/S1 5) Select the preferred decoder. -
Page 20: Specifications
VuStream 150 – User Guide Specifications Network 1x 1Gb/s LAN (POE) Dimensions 15.0 W x 8.2 D x 4.1 H cm (5.9” x 3.26” x1.61”) Power supply 100-240V AC In, 12VDC Out, 20W or over POE Chassis Compact & Fanless Chassis Video input 1x HDMI 2.0 (Type A) with audio support... -
Page 21: Contact Information
VuStream 150 – User Guide Contact Information VuWall Technology, Inc. VuWall Technology Europe GmbH 181 Hymus Blvd, Suite 301 Lustnauer Str. 78 Pointe-Claire, QC, H9R 5P4 72127 Kusterdingen Phone: +1 514 505 4436 Phone: +49 707 15499 206 Web: www.vuwall.com Web: www.vuwall.com...
Need help?
Do you have a question about the VuStream 150 and is the answer not in the manual?
Questions and answers
How do I change the default password
@Tyler Laczko You can't