Download Print this page
GE JX1827 Installation Instructions
GE JX1827 Installation Instructions

GE JX1827 Installation Instructions

Built-in trim kits

Advertisement

Quick Links

Installation
Instructions
Questions? Call GE Answer Center at 800.626.2000
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
instructions for local inspector's use.
IMPORTANT –
governing codes and ordinances.
Note to Installer –
instructions with the Consumer.
Note to Consumer –
instructions for future reference.
FOR YOUR SAFETY:
WARNING –
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.
TOOLS YOU WILL NEED
Phillips screwdriver
Pencil
Awl or punch
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
Save these
Observe all
Be sure to leave these
Keep these
Before beginning the
" bit or #35
Drill with
7
64
Tape measure
.
Built-In Trim Kits
JX1827 and JX1830
or
Visit our Website at:
• Unplug the microwave oven before attempting
installation of this kit.
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 1-3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• This kit is UL listed for installation alone or over any
General Electric/Hotpoint/RCA single electric wall
oven.
PARTS INCLUDED
PART
1
www.GEAppliances.com
QUANTITY
Trim Frame
Bottom Duct
Side Duct
1" Screws
(4 required, 2 extra)
1/2" Screws
(11 required, 4 extra)
Anti-Tip Bracket
Bottom Bracket
Upper Duct
Template
1
1
1
6
15
1
1
1
1

Advertisement

loading

Summary of Contents for GE JX1827

  • Page 1 Installation Built-In Trim Kits JX1827 and JX1830 Instructions Questions? Call GE Answer Center at 800.626.2000 www.GEAppliances.com Visit our Website at: BEFORE YOU BEGIN • Unplug the microwave oven before attempting Read these instructions completely and carefully. installation of this kit.
  • Page 2 Installation Instructions CUTOUT DIMENSIONS INSTALL BOTTOM BRACKET AND BOTTOM DUCT Models 27″ 30″ Disconnect the microwave oven before proceeding with the installation. ″ ″ Height ⁄ ⁄ Fasten the bottom bracket to the bottom duct by ″ ″ Width ⁄ ⁄...
  • Page 3 Installation Instructions INSTALL THE ANTI-TIP BRACKET INSTALL SIDE DUCT AND UPPER DUCT Fold or cut the front edge of the template, along Connect the side duct to the upper duct as shown. the front guide line. Place the template flush along the front edge of the cutout floor, aligning the 1.
  • Page 4 Installation Instructions INSTALL MICROWAVE OVEN INSTALLING THE TRIM FRAME INTO CABINET Place the trim frame over the microwave oven. Slide the microwave oven part way into the cabinet Make sure the trim frame is level and the opening. microwave oven is centered within the trim frame. Mark four center positions through the four Anti-Tip Assembly Bottom Duct...

This manual is also suitable for:

Jx1830Jx1830wbJx1830cbJx1830bbJx1827wbJx1827sb ... Show all