Sealey LINK MONKEY Instructions

Thank you for purchasing a Tru-Tension product. Manufactured to a high standard, this product will, if used according to these instructions, and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT
IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools and equiptment.
• DO NOT use if damaged.
• Maintain in good and clean condition for best and safest performance.
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
• Keep children and unauthorised persons away from the work area.
• Ensure that the motorcycle is safely positioned and secured
2. INTRODUCTION
Breaks and rejoins most types of chain quickly and easily. Suitable for most sizes of drive or cam chain from #420 to #530. Supplied with a range of pins, dies and detailed instructions.
3. SPECIFICATION
MODEL
CONTENTS
4. OPERATION
PRESS GUIDE PINS
2.2mm, 3.2mm, 4mm & 5mm
BREAKING TIPS
2.2mm, 3.2mm, 4mm & 5mm
PRESS
RIVET SET
© Copyright Tru-Tension LTD
Wear safety
Wear protective
gloves
footwaer
Pins: 2.2mm, 3.2mm, 4.0mm & 5.0mm
Pin Guide: 2.2mm, 3.2mm, 4.2mm & 5.2mm
Anvil: 3.2mm & 6mm
Rivet Set
Spring
INSTRUCTIONS FOR
LINK MONKEY - CHAIN BREAKER
SKU: M027
M027
Press Plates
Lever
Handle
Chain Press
PUSH (EXTRACTOR) BOLT
LEVER
ALIGNMENT BOLT
BODY
HANDLE
fig. 1