Sealey TP6901 Manual

thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
TP6901
MANUAL OPERATION ONLY
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health & Safety, local authority, and general
workshop practice regulations are strictly adhered to when using this
equipment.
 WARNING! disconnect the extractor from the air supply before
changing accessories, servicing or performing any maintenance.
 Important! Ensure that you wear protective clothing, gloves,
goggles, face mask as appropriate for the fluid being extracted.
 Keep the extractor clean and maintain it in good condition (use an
authorised service agent).
 replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the
warranty.
 check extractor connections and fittings before use. when the
extractor is turned on check that there are no leaks.
 ensure that the extractor's tank capacity exceeds the amount of
fluid to be collected.
 Avoid unintentional starting of the extractor and ensure that the
end of the suction tube is fully submerged in the fluid before
operating.
 when not in use, disconnect from the air supply and store in a
safe, dry, childproof area.
 Keep the work area clean, uncluttered and ensure there is
adequate lighting.
VACUUM OIL/FLUID EXTRACTORS
MANUAL AND AIR OPERATION 9LTR
InstructIons for models shown below:
TP6903
AIR OPERATION ONLY
 maintain correct balance and footing. ensure the floor is not slippery
and wear non-slip shoes.
 Keep children and unauthorised persons away from the working area.
 dispose of waste fluids in accordance with local authority
regulations.
 WARNING! DO NOT allow uncontrolled discharge of fluids thus
polluting the environment.
 do not pull or yank any pipes or hoses and do not attempt to
move the extractor by pulling the hose.
 do not leave the extractor operating unattended.
 use only to extract engine or transmission oils, or similar non-
corrosive fluids. unit may also be used for the transfer of water.
 do not use to extract hazardous or harmful chemicals, solvents,
petrol, diesel, kerosene, alkaline or acids. If by chance such fluids
are used in the unit, it must be immediately drained and
thoroughly cleaned. use with prohibited fluids will invalidate your
warranty.
 do not store fluids in the extractor's tank. After extracting
fluid, it must be emptied into an approved receptacle as soon as
possible.
 do not dismantle, tamper or adapt the extractor for any purpose
other than for which it is designed.
 do not store in areas of high temperature, direct sunlight, rain or
snow.
 do not direct the air line at yourself or others.
Original Language Version
TP6904
MANUAL AND AIR OPERATION
tP6901, tP6903, tP6904 Issue: 2 - 06/04/10