Sealey AP3503TB.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
‰
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
toolbox combination.
9
Locate the toolbox combination in a suitable working area.
9
Use on level and solid ground, preferably concrete.
9
Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9
Keep the toolbox combination clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT use the toolbox combination for any purpose other than that for which it is designed.
8
DO NOT move the toolbox combination with drawers open. To avoid tipping, open one drawer at a time and close and secure all drawers
whilst moving.
8
DO NOT overload or step on the drawers.
8
DO NOT place the toolbox combination in a damp or wet location or an area where there is condensation.
8
DO NOT clean the toolbox combination with any solvents which may damage the surfaces or the protective coating.
‰
WARNING! The warnings, cautions and instructions referred to in these instructions cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
2. INTRODUCTION
Manufactured with double skin side walls for extra strength and finished in smooth, hi-gloss, triple baked enamel. Resists scratches, oil, dirt and
most solvents. Smooth ball bearing drawer slides provide superior performance and carry heavier loads. For mobility around the workshop, even
when fully laden, the rollcab features hard compound rubber wheels, two fixed and two locking castors. All drawers have been specifically sized
to accommodate our range of Siegen tool trays. Supplied with two keys.
3. SPECIFICATION
Model No: ........................................................AP3503TB.V2
W x D x H:
Overall Size: ............................................605 x 310 x 275mm
Small drawers (3x): ........................... 508 x 268 x 54mm mm
Model No: .........................................................AP3505TB.V2
Overall Size: ..................................... 625 x 305 x 470mm mm
Small Drawers (5x): ...................................508 x 268 x 54mm
Model No: .........................................................AP3508TB.V2
Overall Size: ............................................615 x 330 x 885mm
Overall Size inc. Handle: .........................680 x 330 x 885mm
Small Drawer (5x): ....................................508 x 268 x 54mm
Large Drawer (x3): ....................................508 x 268 x 91mm
© Jack Sealey Limited
3 DRAWER MID-BOX CHEST, 5 DRAWER
TOPCHEST, ROLLCAB 8 DRAWER WITH BALL
BEARING SLIDES - BLACK/GREY
AP3503TB.V2, AP3505TB.V2, AP3508TB.V2
MODEL NO'S:
Original Language Version
AP3503TB.V2, AP3505TB.V2, AP3508TB.V2 Issue: 1 (14/01/22