Sealey POWER PRODUCTS CT01 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
3 Maintain the dispenser in good condition. Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may
be dangerous and will invalidate the warranty.
3 Keep the dispenser clean for best and safest performance.
3 Ensure the workpiece is correctly held or secured before commencing work.
7 DO NOT use the dispenser for any purpose other than for which it is designed.
7 DO NOT operate the dispenser if any parts are missing as this may cause failure and/or possible personal injury.
7 DO NOT attempt to use on humans or animals.
7 DO NOT use for heavy loads over 20lbs.
3 When not in use store in a safe, dry, childproof area.
2. CONTENTS
Suitable for strapping anything from small
cables to large boxes. Fast, efficient with no
more waste. Built-in cutter, automatically cuts
tie to required length after tightening. Comes
complete with a tie reel and clips.
Contents CT01
Gun 1
Clips 100
Tie 10mtr
3. ASSEMBLY INSTRUCTIONS
3.1. Loading Clips.
3.1.1 Remove the spring loader by pressing both sides and pulling apart gently (Fig. A).
3.1.2 Ensure the clip stick is in an upright position, with the arrows on clips facing towards the dispenser.
3.1.3 Insert the clips all the way into the dispenser (Fig. B), withdraw the stick and discard, the clips will remain in the dispenser.
3.1.4 Push the spring loader back into its original position.
NOTE: Only fit the contents of one stick into the dispenser, if the dispenser is overloaded it will jam. If this occurs push the cutter (Fig. A) to
eject some of the clips.
Cutter
Fig. A
CT01R
0
200
12mtr
Spring Loader
INSTRUCTIONS FOR:
CABLE TIE DISPENSER + REFILL
CT01 & CT01R
Model No:
Clip Stick
Fig. B
Push clips all the way in
CT01 & CT01R - 1 - 090805