Advertisement
Quick Links
Brake Cable Kit
21in Heavy-Duty Recycler
Model No. 133-2680
Model No. 136-7000
Use the appropriate kit for your lawn mower model as follows:
•
Lawn mower model no. 22295—kit no. 133-2680
•
Lawn mower model no. 22297—kit no. 136-7000
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
2
1
Removing the Brake Cable
No Parts Required
Procedure
1. Shut off the engine and wait for all moving parts to
stop.
2. Disconnect the spark-plug wire from the spark plug.
3. Disconnect the brake cable from the blade-control bar
(Figure 1
or
Figure 2
the bolt and the nut.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Brake cable
Cable anchor
Screw
as appropriate for your kit); keep
Register at www.Toro.com.
®
/Rear Bagger Lawn Mower
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
Qty.
1
1
Install the brake cable.
1
Kit 133-2680
1. Bolt (keep)
2. Screw (discard)
Original Instructions (EN)
All Rights Reserved *3408-237* A
Printed in the USA
Form No. 3408-237 Rev A
Installation Instructions
WARNING
Use
Figure 1
3. Cable anchor
4. Nut (keep)
g187498
Advertisement
Related Manuals for Toro 133-2680
Summary of Contents for Toro 133-2680
- Page 1 Model No. 136-7000 Installation Instructions Use the appropriate kit for your lawn mower model as follows: WARNING • Lawn mower model no. 22295—kit no. 133-2680 CALIFORNIA • Lawn mower model no. 22297—kit no. 136-7000 Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 5. Disconnect the brake cable from the engine (Figure 3 1. Nut 3. Brake cable Figure 4 as appropriate for your kit), then discard it. 2. Spacer 4. Bolt g187780 Figure 3 Kit 133-2680 1. Brake cable 2. Engine connection location...
- Page 3 Adjusting the Brake Cable 1. Hold the blade-control bar at 19 cm (7-5/8 inches) from the top of the handle as shown in Figure Installing and Adjusting the Brake Cable Parts needed for this procedure: Brake cable Cable anchor Screw Installing the Brake Cable g034988 Figure 6...