Sealey 3S/4R.V3 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMP P OR R TA TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH H E P P RO O DUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE E RS S ON N AL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
 Ensure that the shears are securely mounted on a rigid work surface surrounded by suffi cient free area to manipulate the workpiece
easily and safely.
Always wear suitable Personal Protective Equipment to guard against injury. Protective goggles and gloves are available from your

Sealey Stockist. Non slip footwear should be worn.
 Make sure that the work area is well lit and is kept tidy. The fl oor should be dry and clean.
 DO NOT allow fi ngers or hands to come into close proximity to the cutting wheels and beware of sharp edges and swarf.
 DO NOT use this product if tired or under the infl uence of alcohol or drugs.
 Keep children well away from this product at all times.
2. INTRODUCTION
Manufactured from steel-plate and fi tted with hardened steel shear blades for accurate cutting and long life. Designed to be bolted to the
bench. Suitable for cropping steel sheet and bar.
3. SPECIFICATION
Model No:.......................................................3S/4R.V3 .................................. 3S/5R.V3 ................................3S/6R.V3
Maximum Cut Length: ........................................ 105mm ......................................135mm ................................... 175mm
Round Bar: .......................................................Ø10mm* ....................................Ø11mm* ................................. Ø12mm*
Sheet: .................................................................. 4mm* ........................................ 5mm* ......................................6mm*
Note: *Capacity in Steel
4. ASSEMBLY
4.1. Securely bolt the body of the shear to a strong work surface at a comfortable height.
4.2. Connect both parts of the handle together and attach it to the body.
5. OPERATION
 Ensure that the shears are securely mounted on a rigid work surface
surrounded by suffi cient free area to manipulate the workpiece
easily and safely.
 DO NOT force this machine to cut metals beyond its specifi ed range.
5.1. CUTTING FLAT METAL
5.1.1. Scribe a line on the metal to be cut.
5.1.2. Line up scribe mark with jaws and pull handle.
5.1.3. If required, use the adjustable support rod to stop metal from
deforming while cutting.
5.1.4. Extend the handle for the thicker metals.
5.1.5. When cutting a sheet of metal, take small cuts and feed the sheet
into the jaws being careful to keep your fi ngers clear of the jaws.
If the sheet of metal is awkward make sure you have assistance.
5.2. CUTTING ROUND BAR
5.2.1. Round bar can be cut using the bar cutting hole in the blade.
6. MAINTENANCE
6.1. Lightly oil moving components.
© Jack Sealey Limited
METAL CUTTING SHEARS
MODEL NO:
Wear protective
gloves
Original Language Version
3S/4R.V3, 3S/5R.V3, 3S/6R.V3
fi g.1
Bar Cutter
Adjustable
Support Rod
3S/4RV3, 3S/5R.V3, 3S/6R.V3, Issue 2 (3) 09/11/21