Related Manuals for GE VT4010M
Summary of Contents for GE VT4010M
- Page 1 GE Security Installation/Operation Instructions Warranty Information VT4010M VT4020M VT4025M www.ifs.com 888-999-9IFS...
- Page 2 (within the housing) without the need for a coaxial cable. This transmitter utilizes FM (frequency modulation) techniques to produce “near-broadcast quality” video images. PART NUMBER DESCRIPTION VT4000M SERIES VT4010M FM VIDEO MINI-TRANSMITTER: 850 nm, ONE MULTIMODE FIBER VT4020M FM VIDEO MINI-TRANSMITTER: 1300 nm, ONE MULTIMODE FIBER...
-
Page 3: Fiber Optic Connection
FIBER OPTIC CONNECTION Select a quality fiber optic cable containing either 62.5/125 multimode fiber or 9/125 single mode µ fiber. Attach ST style fiber optic connectors using the connector manufacturer's recommended procedures. Attach one end of the fiber optic cable to the ST connector on the VT4000M Series module. Attach the opposite end of that fiber to the ST connector of a compatible IFS video receiver. - Page 4 To VR4010 Series Module One 62.5/125 multimode fiber optic cable VT4010M FM VIDEO XTMR Black wire POWER GRD - 4 Power + 12 VDC - 3 Black with white stripe VIDEO IN - 2 VIDEO GRD - 1 203.426.1180 WWW.IFS.COM...
- Page 5 To VR4030 Series Module One 62.5/125 multimode fiber optic cable VT4020M FM VIDEO XTMR Black wire POWER GRD - 4 Power + 12 VDC - 3 Black with white stripe VIDEO IN - 2 VIDEO GRD - 1 203.426.1180 WWW.IFS.COM Video source Coax cable...
- Page 6 To VR4030 Series Module One 9/125 singlemode fiber optic cable VT4025M FM VIDEO XTMR Black wire POWER GRD - 4 Power + 12 VDC - 3 Black with white stripe VIDEO IN - 2 VIDEO GRD - 1 203.426.1180 WWW.IFS.COM Video source Coax cable...
-
Page 7: Fcc Compliance
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by International Fiber Systems, Inc. - Page 8 Product Disassembly Instructions for WEEE Per European Directive 2002/95/EC Waste Electrical and Electronic Equipment Required Tools: One number 2 Phillips (crosstip) screwdriver. One number 2 flat screwdriver. For the enclosed box version: 1. Locate and remove box cover securement screws. Usually, but not limited to, at least 4 screws.