Sealey FPS5.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction gloves
manual
1. SAFETY
WARNING! Before use, ensure that there is nothing attached to the front forks, the fairing, or the rear end of the motorcycle, that
‰
will foul the stand.
DO NOT mount the stand on tarmacadam, as the surface may be unstable.
8
DO NOT start the motorcycle when mounted on the stand.
8
DO NOT sit on the motorcycle when mounted on the stand.
8
DO NOT use the stand for a purpose it is not designed to perform.
8
DO NOT operate the stand if it is damaged or parts are missing.
8
DO NOT use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT allow untrained persons to operate the stand.
8
DO NOT make any modifications to the stand.
8
DO NOT operate the stand if parts are missing or damaged.
8
Maintain the stand in a good clean condition for the best and safest performance.
9
Locate the stand and motorcycle in a suitable area. Keep area clean, tidy and free from unrelated materials and ensure that there is
9
adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight of the stand
and the motorcycle.
Maintain correct balance and footing whilst positioning the motorcycle on the stand, DO NOT over reach.
9
Ensure that the floor is not slippery, wear non-slip footwear.
9
Keep children and unauthorised persons away from the work area.
9
Before loading or removing a motorcycle to/from the stand, ensure that there are no obstructions or persons around the motorcycle.
9
Always support bike to prevent falling.
9
Although the stand can be operated by one person, we advise seeking the assistance of a second person when mounting / dismounting
9
the stand.
Always use in conjunction with another suitable rear stand to ensure full stability.
9
When not in use, store in a safe, dry, childproof location.
9
WARNING: The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may occur.
‰
It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied
by the operator.
2. INTRODUCTION
Strong tubular frame supplied with a range of pins to fit the most common headstock sizes. Once in place, access to all mechanical
components at the front of the bike is made easily. Stand folds down for compact storage when not in use. Adjustable to suit different
head stock heights.
3. SPECIFICATION
Model No: ..................................................................... FPS5
Headstock Height ................................................ 830-925mm
Headstock Pin sizes ................................. 15,16,18,20,24mm
4. ASSEMBLY
4.1. Refer to Parts List diagram.
4.2. Ensure all fixings are correctly tightened and that frame members are securely fitted.
4.3. Ensure all parts are present and in good order. DO NOT use parts other than those supplied.
© Jack Sealey Limited
INSTRUCTIONS FOR
FRONT HEADSTOCK STAND
FPS5.V2
MODEL NO:
Original Language Version
FPS5.V2 Issue 1 03/04/18