PulseWorx KPC 8 Series Installation Manual And Owner's Manual

FUNCTION
The 8-Button Keypad Controller (KPCx8) is a high quality
home automation controller that is capable of transmitting
UPB (Universal Powerline Bus) digital commands over the
existing power wiring to remotely turn on, off, and dim other
UPB load control devices. No additional wiring is required
and no radio frequency signals are used for communication.
Wall-Mount and Desktop Styles
The KPCx8 is available in two different styles: wall-mount and
desktop. The KPCW8 is the wall-mount version and can be
mounted in any wall box that contains both line and neutral
wires. The KPCD8 comes in an elegant desktop enclosure
that can be freely located near any wall outlet that exists
throughout the home.
Engraved Pushbuttons
The KPCx8 has eight backlit pushbuttons engraved with the
designations of: E, F, G, H, I, J, K, and L. A Custom Engraved
Membrane kit (model CEM8) is available enabling you to
tailor each button for its particular use. Consult your dealer
or our website (www.PulseWorx.com) for CEM8 ordering
information.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic safety precautions
should always be followed, including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2. Keep away from water. If the product comes in contact
with water or other liquid, turn off the circuit breaker and
unplug the product immediately.
3. Never use products that have been dropped or
damaged.
Models: KPCW8 & KPCD8
Keypad Controllers
The Inventors Of:
Installation Guide and
4. Do not use this product outdoors.
5. Do not use this product for other than its intended purpose.
6. Do not cover this product with any material when in use.
7. This product uses polarized plugs and sockets (one blade is
larger than the other) to reduce the risk of electric shock.
These plugs and sockets fit only one way. If they do not fit,
consult an electrician.
8. SAVE THESE INSTRUCTIONS.
INSTALLATION
The Keypad Controllers are designed for indoor use. Simply plug
the KPCD8 into any 120V power outlet. To install the KPCW8
module in a wall box follow these instructions:
1. Before installing the KPCW8 into a wall box, ensure that
power to the wall box has been disconnected by removing
the fuse or turning the circuit breaker off. Installing
products while the power is on may expose you to
dangerous voltage and may damage the product as well!
2. Remove any existing wall plate and device from the wall
box.
3. Use wire nuts to securely connect the KPCW8's white wire
to the "Neutral" wire and the KPCW8's black wire to the
"Line" wire (see illustration below).
4. Fit the KPCW8 into the wall box and secure with mounting
screws. Install the wall plate.
5. Restore power at the circuit breaker.
Neutral
(White)
19201 Parthenia St. Suite J
Northridge, CA 91324
(Phone) 818-701-9831 (Fax) 818-701-1506
sales@pcslighting.com www.pcslighting.com
Owner's Manual
Wall
Box
Line
(Black)