Sealey AP223 Instructions

Thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safeTy
do NoT open more than one draw at a time.
8
close lid, lock draws before moving.
9
do NoT stand on the tool boxes
8
do NoT mount the tool box on a truck bed or any other moving object.
8
Apply brakes on swivel casters when not moving unit.
9
do NoT pull the tool box when moving, only push to move.
8
do NoT stand inside the draws.
8
2. iNTroducTioN
manufactured from double skin side walls for extra strength and finished in a smooth, hi-gloss triple baked enamel. Resists scratches, oil,
dirt and most solvents. Topchests and mid-boxes feature 35mm ball bearing runners and recessed carry handles. Rollcabs feature 45mm
ball bearing runners, side handle and four castors (two fixed and two locking) for mobility around the workshop, even when fully laden. Each
drawer face has full length pulls with chrome style trims. All chests are supplied with tumbler type security locks and two numbered keys.
3. operaTioN
3.1. Topchest.
3.1.1. to lock the tool box. make sure all draws are closed, close lid,
turn key anti-clockwise.
3.1.2. to unlock the tool box.turn key clockwise and pull open draw.
3.2. mid-box / rollcab.
3.2.1. to lock the tool box. make sure all draws are closed, turn key
anti-clockwise.
3.2.2. to unlock the tool box.turn key clockwise and pull open draw.
do NoT slam the draws shut as damage may occur to the
8
lock bar tabs or lock pockets.
3.3. To remove draws.
3.3.1. empty draw and pull out until it stops.
3.3.2. release the black retaining clips by pushing the righthand side
clip up and the left hand side down simultaneously, and pulling
the draw out fig.1.
3.3.3. To re-install draws, place draw onto slides and push in.
3.4. casters and side handle.
3.4.1. roll cabinet is supplied with heavy duty castors, including two
swivel castors. Fix as shown in fig.2.
3.4.2. The side handle must be fixed on the same side as the swivel
castors, by inserting handle through slots in side of cabinet and
fixing in place with the four set screws provided.
© Jack sealey limited
instructions for
Toolbox - TopchesT, mid-box, rollcab
ap223, ap225, ap226
model no:
ap223b, ap225b, ap226b.
Original Language Version AP223(B),AP225(B),AP226(B) | Issue 1 27/10/16
fig.1
fig.2