Sealey AP2200BB.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you
years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/
OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1 GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop
practice regulations are adhered to when using this Topchest & Rollcab
combination.
Locate Topchest & Rollcab combination in a suitable working area.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
Keep the Topchest & Rollcab combination clean and tidy in accordance with
good workshop practice.
Keep children and unauthorised persons away from the working area.
DO NOT use the Topchest & Rollcab combination for any purpose other than
that for which it is designed.
DO NOT move the Topchest & Rollcab combination with drawers open.
DO NOT open more than one drawer at the same time.
DO NOT step on the drawers.
DO NOT use in damp work areas.
WARNING! The warnings, cautions and instructions referred to in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood that common sense and caution are factors which cannot be
built into this product, but must be applied by the operator.
2. INTRODUCTION & SPECIFICATIONS
The economical way to buy American Pro quality toolboxes. Supplied packed
one inside the other. This mid-size combo has all the features of the professional
chests except that the rollcab is not lockable and the castors are Ø75mm. These
boxes are not interchangeable with the rest of the American Pro Range.
Model No: AP2200.V3
4 Drawer Topchest
Overall Size: 598 x 260 x 338mm
Small Drawer (x3): 514 x 224 x 37mm
Medium Drawer (x1): 514 x 224 x 82mm
2 Drawer Rollcab
Overall Size: 616 x 298 x 700mm
Medium Drawer (x2): 516 x 275 x 65mm
Maximum Load: 70kg
3. ASSEMBLY
fig.1
3.1
Remove the bolts, nuts and washers from the base of the rollcab, (fig.1) and then lift off the body to uncover the topchest.
3.2 Remove the screws from the base, (fig.2) and separate from the topchest, discard the screws.
Note: Place protective material onto the ground to avoid damaging the back of the topchest.
INSTRUCTIONS FOR:
TOPCHEST & ROLLCAB
COMBINATION 6 DRAWER
MODEL No:
X4
M6
X1 X18
X18 X18
fig.2
AP2200BB.V2
AP2200
AP2200BB.V2 Issue No: 1 - 30/03/12