Sealey VEN200.V4 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
1.1. ELECTRICAL SAFETY
WARNING! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and all
electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products. You may obtain an RCD by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable Appliance
Test) tested.
Electrical safety information: it is important that the following information is read and understood.
1.1.1. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3. Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct
fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or
8
replaced immediately by a qualified electrician.
1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
A) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
B) Connect the BROWN live wire to the live terminal 'L'.
C) Connect the BLUE neutral wire to the neutral terminal 'N'.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.2 GENERAL SAFETY
Disconnect the ventilator from the mains power when not in use, and before servicing or performing any maintenance.
9
Use the fan in dry areas only. Do not use in wet or high condensation locations such as bathrooms, showers, or pools.
9
WARNING! If a ventilator falls into water, immediately switch off at the mains and disconnect from the mains power supply.
‰
DO NOT touch the ventilator until the mains power supply has been disconnected.
8
Always disconnect the ventilator from the power supply when moving it from one location to another.
9
Keep the ventilator clean and maintain in good condition (use an authorised service agent).
9
Use recommended parts only (unauthorised parts may be dangerous, and will invalidate your warranty).
9
DO NOT stand the ventilator where it may be knocked over or off a surface, or where the lead may cause a trip hazard.
8
DO NOT use an extension cord unless it has been approved by an electrical authority.
8
DO NOT insert any objects through the fan guard.
8
DO NOT allow children to operate the ventilator.
8
DO NOT immerse the ventilator in water or any other liquid.
8
DO NOT use the ventilator outdoors.
8
DO NOT cover the ventilator.
8
When not in use store in a safe, dry, childproof location.
9
2. INTRODUCTION
Ideal for use where high volume air delivery is required. Especially suitable for ventilating confined, hot or fume laden work sites, typically as
found in boats, cable/pipe ducts, roof spaces creating a cleaner more pleasant working environment. Lightweight and robust construction give
the portability and durability necessary in the workplace. Fitted with carry handle, 2m cable and 3-pin plug. Supplied with 5m ducting, optional
10m length available.
© Jack Sealey Limited
PORTABLE VENTILATORS WITH DUCTING
VEN200.V4, VEN250.V2, VEN300.V3
MODEL Nos:
Original Language Version VEN200.V4, VEN250.V2, VEN300.V3
Replacement fuse
rating:3A
Issue: 1 16/03/21