Advertisement
Quick Links
IBM Security Hardware
Power Supply Replacement Instructions
This document helps you to complete the following tasks:
v Identify a failed power supply
v Remove the failed power supply and replace it with a new power supply
v Verify that the replacement power supply is working correctly
Important: Before you proceed with these instructions, review the IBM Systems Safety Notices provided in
the IBM Media Terms and Conditions CD that is included with your appliance model.
Note: The illustrations in this document might differ slightly from your appliance model.
Supported appliances
The following table lists the appliance models that are supported by the instructions in this document:
Product
IBM Security Access Manager
IBM Security Network Protection
IBM Security SiteProtector
Model
AMP 5100
ISAM V9.0
XGS 3100
XGS 4100
XGS 5100
™
System
SP 4001
®
IBM
Part Number
97Y0608
97Y1070
00VM247
97Y0977
97Y0823
97Y0612
97Y1346
Advertisement
Related Manuals for IBM AMP 5100
Summary of Contents for IBM AMP 5100
- Page 1 Remove the failed power supply and replace it with a new power supply v Verify that the replacement power supply is working correctly Important: Before you proceed with these instructions, review the IBM Systems Safety Notices provided in the IBM Media Terms and Conditions CD that is included with your appliance model.
- Page 2 CAUTION: The power control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all current from the device, ensure that all power cords are disconnected from the power source.
- Page 3 Identifying a failed power supply Each power supply unit uses an LED that indicates whether the unit is working as expected. Figure 1 describes the LEDs that are displayed by the power supply units for the appliance: Figure 1. Power supply LEDs The following table indicates the potential problems that can occur with the power supply and suggests actions for you to use to correct the detected problems: Table 1.
- Page 4 Table 1. Power supply LED combinations for detecting potential problems (continued) Error Description Action Notes No AC power is going to This condition occurs when 1. Replace the power the appliance, or there is a a second power supply is supply.
-
Page 5: Replacing A Failed Power Supply
Replacing a failed power supply Before you begin When you replace a failed power supply, make sure that you do not unplug the power supply unit that is working because this action disrupts service to the appliance. Procedure Complete the following steps to replace a failed power supply: 1. - Page 6 The two power LEDs are to the left of the power cord connector. First edition: August 2013 © Copyright IBM Corporation 2013, 2015. US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
Need help?
Do you have a question about the AMP 5100 and is the answer not in the manual?
Questions and answers