Sealey SFF12.V2 Instructions

Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. safeTY
1.1. eLeCTRICaL safeTY
WaRnInG! it is the user's responsibility to check the following:
‰
check all electrical equipment and appliances to ensure that they are safe before using. inspect power supply leads, plugs and
all electrical connections for wear and damage. sealey recommend that an rcd (residual current device) is used with all electrical
products. You may obtain an rcd by contacting your local sealey dealer.
if the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAt (Portable
Appliance test) tested.
electrical safety information, it is important that the following information is read and understood.
1.1.1. ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2. regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3. Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
dO nOT pull or carry the appliance by the power cable.
8
dO nOT pull the plug from the socket by the cable. Remove the plug from the socket by maintaining a firm grip on the plug.
8
dO nOT use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or replaced immediately by a
8
qualified electrician.
1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.
if the cable or plug is damaged during use, switch the electricity supply and remove from use.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
class ii products are wired with live (brown) and neutral (blue) onlyare marked with the
class ii symbol;
A) Connect the BROWN live wire to the live terminal 'L'.
B) Connect the BLUE neutral wire to the neutral terminal 'N'.
c) After wiring, check that there are no bare wires and ensure that all wires have been correctly
connected.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
dO nOT connect either wire to the earth terminal.
8
Sealey recommend that repairs are carried out by a qualified electrician.
1.2. GeneRaL safeTY
disconnect the fan from the mains power when not in use and before servicing or performing any maintenance.
9
use the fan in dry areas only. dO nOT use in wet or areas with high condensation such as showers, pools etc.
9
‰ ‰ WaRnInG! if a fan falls into water or other liquid, immediately switch off and disconnect from the mains power supply. dO nOT touch
‰
‰
the fan until the mains power supply has been disconnected.
Always disconnect the fan from the power supply when moving it from one location to another and ensure fan is stood on a level
9
‰ ‰ ‰
surface.
‰ ‰ The fan air flow is powerful. Before use ensure that there is nothing nearby that will be damaged or displaced by the stream of air.
9
‰
‰ ‰ Keep the fan clean and maintained in good condition. for motor service contact an authorised service agent.
9
‰
‰ ‰ use recommended parts only. unapproved parts may be dangerous, and will invalidate your warranty.
9
‰
dO nOT operate the fan where there are explosive or flammable gases, fumes or other hazardous substances.
‰ 8
‰ ‰
dO nOT stand the fan on the power cable.
8
dO nOT insert any objects through the fan guard.
8
dO nOT cover the fan when in use.
8
dO nOT immerse the fan in water or any other liquid.
8
dO nOT stand the fan where it may be knocked over or off a surface, or where the lead may cause a person to trip.
8
dO nOT use the fan outdoors.
8
dO nOT modify speed control or attempt to fit any additional external speed control device to the fan.
8
© Jack sealey limited
instructions for
desk fan 3-speed 12" 230V
sff12.V2
model no:
Original Language Version
recommended fuse rating
3 Amp
sFF12.V2 | Issue:2 (H,F) 04/12/17