Sealey WS650.V2 Instructions

Your new Wheel skate is produced and manufactured to a high standard of dependability and will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
Important: Read these instRuctions caRefully. note the safe opeRational ReQuiReMents, WaRnings and cautions. use
these skates coRRectly and With caRe foR the puRpose foR Which they aRe intended. failuRe to do so May cause
daMage and/oR peRsonal injuRy and Will inValidate the WaRRanty. Retain these instRuctions foR futuRe use.
1. safety pRecautions
WaRning! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.

familiarise yourself with this product's application and limitations, as well as the specific warnings below relating to their use.

ensure the Wheel skates are in sound condition and good working order. take action for immediate repair or replacement of damaged

parts.
Use genuine parts only. The use of improper parts may be dangerous and will invalidate the warranty.
Wheel skates should only be used in suitable, well lit areas.

Wheel Skates must be used in pairs at either the front or rear of the vehicle.

they must never be used diagonally.
Keep general area clean and tidy and free from obstructions.

use Wheel skates on level and solid ground, preferably concrete. Avoid tarmacadam

as Wheel Skates may sink in.
Maintain the Wheel skates in good condition (use an authorised service agent).

ensure there are no passengers in the vehicle.

ensure the Wheel skates are free to move and that there are no obstructions in the

area of use.
When not in use store Wheel skates in a safe, dry, childproof area.

DanGEr: Use the Wheel skates for manoeuvring or positioning of vehicles in interior

situations. They are not designed for use outdoors.
do not start or drive the vehicle whilst it is raised on wheel skates.
do not use the Wheel skates for purposes other than that for which they are

intended.
do not allow untrained persons to operate the Wheel skates.

do not leave the vehicle unattended whilst it is raised on the Wheel skates.

do not operate the Wheel skates when you are tired or under the influence of alcohol, drugs or intoxicating medication.

do not get the Wheel skates wet or use in damp or wet locations or areas where there is condensation.

do not exceed the rated capacity of the Wheel skates. remember that the front of a vehicle is usually heavier than the rear.

do not use the Wheel skates to lift or support a vehicle in order to do work underneath it.

Maintain correct balance and footing when moving vehicle. ensure the floor is not slippery and wear non-slip shoes.

ensure there are no obstructions beneath the vehicle when it is to be lowered.

ensure all non-essential persons keep a safe distance whilst the Wheel skates are in use.

iMpoRtant - We recommend that at least 2 persons are involved in manoeuvring the vehicle when supported on wheel skates. the
vehicle's weight provides a large amount of inertia which has to be overcome to get the vehicle moving and more importantly, stopped.
WaRning! The warnings, cautions and instructions covered in this manual cannot cover all possible conditions and situations that may

occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. intRoduction & specification
steel chassis with PVc rollers and four Ø100mm nylon castors. Pedal operated hydraulic lifting action with safety locking pin when under
load. rollers cradle vehicle's tyre and are capable of handling up to 300mm profile. suitable for bodyshops, garages, showrooms or anywhere
a disabled vehicle needs moving on an even surface.
note: skates sold as singles, but must be used in pairs.
lifting capacity per skate: . . . 650kg
Wheel Ø: . . . . . . . . . . . . . . . .Ø100mm
3. opeRating instRuctions
3.1. preparation.
3.1.1. ensure that the area where the vehicle is to be moved is clear of any obstructions. the floor surface should be smooth and level.
take note of any features in the floor, that may catch the skate wheels or cause damage to the floor surface, such as floor mounted
power and data points, room divider tracks, drainage features etc.
3.1.2. enlist sufficient manpower to move the vehicle safely. Do not attempt to move the vehicle into an area where there is insufficient space
to manoeuvre the vehicle safely.
3.1.3. Prior to operation, release the foot pedal from the transit hook by depressing
the pedal slightly and moving the hook to one side to allow the pedal to rise
up (fig.1).
3.1.4. Wheel skates must be used as a pair. Attach to the front wheels to swing
the front of the vehicle. (Do not release the hand-brake or remove
wheel chocks until both skates are attached. re-engage the hand-brake or
chock the wheels immediately after any movement has been made. Attach to
the rear wheels to swing the rear of the vehicle (ideally the front wheels
should be straight). If it is intended to use two pairs of skates to move a
vehicle in one movement, great care should be exercised in order to avoid
injury to persons or property.
Refer to section 1 before using the wheel skate.
Maximum opening: . . . . 625mm
Weight (each): . . . . . . . . . . 17kg
InstructIons for:
Wheel skate 650kg capacity
MoDel no: Ws650.V2
Maximum tyre profile:. . . . . . . . . . . 250mm
fig.1
Ws650.V2 Issue: 1 - 06/01/12