Sealey Premier CST983HD Instructions

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear safety
instructions footwear
1. Safety
Always load evenly with the centre of gravity of the load as near the centre and rear of the plate as possible.
9
obtain additional support for large or wide loads to prevent tipping.
9
Do not overload the truck - see Specification.
8
Do not leave unattended, especially when loaded, unless the wheels are chocked or the truck is otherwise secured.
8
Do not use truck on uneven ground and do not run over curbs or steps - use a ramp.
8
Do not allow others to ride on the truck.
8
Do not use the truck if any part is damaged, paying particular attention to the wheels.
8
2. introDuction
Heavy-duty tubular steel construction with welded joints with an extra 50kg capacity to the standard models. Puncture proof heavy-duty PU
tyres with powder coated steel hubs and fitted with knuckle protecting D-shaped handle grips. 3 year warranty.
3. SPecification
Model no: ...............................CST983HD ............................ CST986Hd ............................. CST987Hd
Capacity: ......................................... 200kg .....................................250kg ......................................250kg
Height(s): .................................... 1150mm .................................1150mm ..................................1220mm
nett Weight: ..................................... 8.3kg ..................................... 9.4kg .....................................10.4kg
overall Width: ............................... 470mm .................................. 525mm ....................................540mm
Platform depth: ............................. 220mm .................................. 180mm ....................................250mm
Wheel Bore Size: ......................... Ø16mm ..................................Ø16mm ...................................Ø16mm
Wheel Size: ................................ Ø210mm ................................Ø250mm ................................. Ø250mm
Wheel Width:................................... 55mm .................................... 85mm ......................................85mm
4. aSSeMbly
4.1. Wheels. ensure axle is clean from dust and dirt to allow free movement of the
wheel.
4.2. For Model no's. CST987Hd and the axle (fig.1.1) needs to be put through the
frame before the wheels can be attached.
4.3.
Slide the wheel (fig.1.2) onto the axle, put on the washer (fig.1.3) and complete by
pushing the split pin (fig.1.4) through the hole in the end of the axle and bending
over to retain.
4.4. Repeat for the other side.
© Jack Sealey limited
Heavy-Duty Sack truck witH Pu tyreS
250kg caPacity
Model no:
cSt983HD, cSt986HD and cSt987HD
Original Language Version
fig.1
CST983HD, CST986HD, CST987HD Issue 1 15/02/19