Sealey AK303.V2 Instructions

Thank you for purchasing a Sealey Product.. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: ACCIdENTS MAY OCCUR IF TOOLS ARE INCORRECTLY USEd ANd/OR TOOLS ARE NOT MAINTAINEd IN A
SAFE CONdITION. IT IS THE RESPONSIBILITY OF THE USER, TO ENSURE THAT TOOLS ARE CORRECTLY USEd ANd
MAINTAINEd. PLEASE REAd THESE SAFETY INSTRUCTIONS CAREFULLY. NOTE THE SAFE REQUIREMENTS FOR USE,
WARNINGS ANd CAUTIONS. USE TOOL CORRECTLY ANd WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENdEd.
FAILURE TO dO SO MAY CAUSE dAMAGE ANd/OR PERSONAL INJURY. PLEASE KEEP INSTRUCTIONS FOR FUTURE
USE.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations
are adhered to when using this equipment.
 WARNING! Wear approved safety eye protection when using this set. (standard spectacles are
not adequate protection.
 dO NOT hold the workpiece by hand. Use clamps or a vice to secure the workpiece.
 dO NOT use the tool for any purpose other than that for which it is designed.
 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous
and will invalidate the warranty.
 Remove ill fitting clothing and wear appropriate protective clothing. Remove ties, loose jewellery,
and contain and/or tie back long hair.
 Keep work area clean and uncluttered and ensure that there is adequate lighting.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
 dO NOT use tool when tired or under the influence of alcohol, drugs or intoxicating medication.
 Keep children and unauthorised persons away from the working area.
 Keep cutting tools lubricated at all times to ensure extended tool life, and also cleaner, more
accurately formed threads.
 When not in use, return all parts to the case, and store in a safe, dry, childproof location.
2. INTROdUCTION
Precision machined, Tungsten steel taps and dies. Dies are split to facilitate the fine adjustment of
core diameter. Set includes Metric coarse and fine sizes. Also includes sliding jaw type tap wrench and
t-Bar type tap wrench together with steel die holder with knurled screws.
Tap drills & Screw Thread Chart -
preferred thread.
nominal
∅ of Pitch tapping
threads (P) in Drill ∅
in mm. mm. in mm.
M6 0.75 5.20
M6 1.00 5.00
M8 1.00 7.00
M8 1.25 6.80
M10 1.25 8.80
M10 1.50 8.50
M12 1.50 10.50
M12 1.75 10.20
M14 1.50 12.50
M14 2.00 12.00
nominal
∅ of Pitch tapping
threads (P) in Drill ∅
in mm. mm. in mm.
M16 1.50 14.50
M16 2.00 14.00
M18 1.50 16.50
M18 2.50 15.50
M20 1.50 18.50
M20 2.50 17.50
M22 1.50 20.50
M22 2.50 19.50
M24 1.50 22.50
M24 3.00 21.00
Original Language Version
InstRuctIons FoR:
TAP & dIE SET 45pc METRIC
Model No. AK303.V2
AK303.V2 Issue: 1 - 06/09/10