Sealey SA4001 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Instruction
Manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
p
WARNING! Disconnect the equipment from the air supply before changing accessories, servicing or performing any maintenance.
p
Keep the equipment clean and maintain it in good condition (use an authorised service agent).

Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.

WARNING! Ensure that the correct air pressure is maintained and not exceeded.
p
Keep air hose away from heat, oil and sharp edges. Check air hoses for wear before each use and ensure that all connections are
p
secure.
DO NOT install in direct sunlight or near any other heat source.

DO NOT direct air from the air hose at yourself, others or animals.

Drain the air tank daily. Water in the air line will damage equipment.

When work is complete ensure that the air supply is turned off.

If in any doubt about correct installation of this equipment consult a competent engineer.

2. INTRODUCTION
Suitable for most workshop air supply set-ups. Die-cast control heads with clear polycarbonate bowls. Regulator assembly features locking control
knob for pre-setting air pressure and large, easy-to-read pressure gauge. Filter is fitted with automatic drain tap. Lubricator includes oil/air mix
control and sight glass. Filter and lubricator are fitted with metal bowl cages for protection. Supplied with wall bracket.
SA4001
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . SA4001 . . . . . . . . . . SA4001F . . . . . . . . . . . SA4001FR . . . . . . . . . . SA4001L . . . . . . . . . . . .SA4001R
Port Size: . . . . . . . . . . . . . . . . . . . . . 1/2"BSP . . . . . . . . . . 1/2"BSP . . . . . . . . . . . . 1/2"BSP . . . . . . . . . . . . 1/2"BSP . . . . . . . . . . . . . .1/2"BSP
Maximum Working Pressure: . . . . . . 145psi . . . . . . . . . . . 145psi . . . . . . . . . . . . . 145psi . . . . . . . . . . . . . 145psi . . . . . . . . . . . . . . . . 145psi
Maximum Airflow: . . . . . . . . . . . . . . . 99cfm. . . . . . . . . . . . 135cfm. . . . . . . . . . . . . 135cfm . . . . . . . . . . . . . 145cfm. . . . . . . . . . . . . . . 210cfm
© Jack Sealey Limited
INSTRUCTIONS FOR:
AIR FILTER/REGULATOR/LUBRICATOR UNITS
MODEL NO'S:
SA4001F SA4001FR
Original Language Version
SA4001, SA4001F, SA4001FR,
SA4001L, SA4001R
SA4001L
SA4001,SA4001F,
SA4001FR,SA4001L, SA4001R
SA4001R
Issue:1 - 13/01/16