Sealey CX105.V3 Manual

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. safety
warNING! ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this trolley.
‰
Always load evenly with the centre of gravity of the load as near centre of the trolley as possible.
9
do Not overload the trolley - see specifications.
8
Use the trolley in a suitable work area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the trolley clean and tidy in accordance with good workshop practice.
9
do Not use the trolley for any purpose other than that for which it is designed.
8
do Not stand on the trolley, use it as a ladder or allow others to ride on the trolley.
8
Use the wheel locks to prevent the trolley from inadvertently moving.
9
do Not leave unattended, especially when loaded, unless the wheels are locked, chocked or the trolley otherwise secured.
8
do Not use trolley on uneven ground and do not run over curbs or steps - use a ramp.
8
do Not use trolley if any part is significantly damaged, paying particular attention to the wheels.
8
Keep children and unauthorised persons away from the work area.
9
2. INtroduCtIoN
Ideal for regularly used workshop items such as body repair kits, power tools and bulky equipment too big for a tool chest. Strong build quality
and extra large castors also make this an excellent dismantling trolley for smaller vehicle components.
3. speCIfICatIoN
Model No: ................................................................. CX105.v3 ................................................. CX108.v3
overall Size (W x d x H): .......................... 840 x 405 x 810mm ..................................840 x 405 x 810mm
Shelf Size (W x d x H): ............................... 790 x 400 x 80mm ....................................790 x 400 x 80mm
Capacity: ...................................................... 100kg (50kg/level) .................................... 150kg (50kg/level)
4. asseMbly
4.0.1. Attach posts to trays (fig.1)
4.0.2. Lay one tray (the one with the four sets of castor holes on the bottom) on the floor and attach posts to the outside corners of the
tray using 32 x M6 short bolt and nut sets.
4.0.3. Attach the other tray to the inside top of the posts using 32 x M6 short bolt and nut sets (fig.2).
4.0.4. Put the trolley on its side and work on two posts at a time,for ease of assembly.
© Jack Sealey limited
2/3 level heavy duty workshop
trolley
Model no:
fig.1
Original Language Version
CX105.v3 & CX108.v3
fig.2
fig.3
CX105.V3 CX108.V3 Issue 2 10/08/18